Is installing shocks hard?
Shocks are relatively simple and cheap. Struts are more complicated and you will need a spring compressor to remove the springs. After replacing the front struts you will need to get a wheel alignment.
Is the front shock the same as the rear strut?
The words “shocks” and “struts” are often used interchangeably, but they aren’t the same thing. Each wheel on your car has either a shock or a strut, never both; although, a vehicle may have struts in the front and shocks in the rear. Consult your owner’s manual or speak to an Advance Team Member to be sure. We’ll take you through the basics below.
What’s the most difficult part of replacing shocks?
The most difficult part of the job is removing the old shocks, which can have a tendency to be really gunky with both age and road-grit, making the bushings and bolts somewhat difficult to remove. Check out the mountings to see if they’re loose enough to get off, or if you’re likely to crack the rubber around the bushing.
Can you adjust the height of the shocks on a truck?
These are adjustable, which means you can alter the height of your truck for optimum performance.
How to replace shocks and struts in Ford Focus?
Replace the Front Shocks and Struts in a Focus. Raise the car with a floor jack and support the frame on jack stands. Use a tire iron to remove the bolts holding on the front wheel. Set the wheel aside. Locate the strut under the front end of your Focus.
The words “shocks” and “struts” are often used interchangeably, but they aren’t the same thing. Each wheel on your car has either a shock or a strut, never both; although, a vehicle may have struts in the front and shocks in the rear. Consult your owner’s manual or speak to an Advance Team Member to be sure. We’ll take you through the basics below.
How do you install shocks on a truck?
Install the two main mounting hardware and attach the new shock to the truck, starting with the upper shock bolts and washers. Use your hands to tighten them. Re-mount the bottom of the shock into the new shock extension.
How do you replace front shocks on a Mercedes Benz?
Remove the top nut (s) in the engine bay. (There will be a plastic dust cover over the shaft assembly at the top.) Use a metric allen wrench to keep the strut shaft from turning while you loosen and remove the nut. Once loosened, you can use the 16mm deep socket to remove the 2 top nuts. Figure 3.
The most difficult part of the job is removing the old shocks, which can have a tendency to be really gunky with both age and road-grit, making the bushings and bolts somewhat difficult to remove. Check out the mountings to see if they’re loose enough to get off, or if you’re likely to crack the rubber around the bushing.