How to remove a clutch slave cylinder in a Hyundai?
They are kinda hard to see and the brake booster makes it a little more difficult. Disconnect the fluid line running from the master cylinder to the driver side motor mount and these two bolts. Take out the pin on the rod connecting the clutch pedal to the master cylinder and it should simply slide out.
How do you bleed air from a slave cylinder?
Adding the new parts introduces air into the system, which creates a soft or non-existent clutch action when you press the pedal. To bleed air from the hydraulic clutch system, you must release air from the slave cylinder.
How to bleed the clutch on a master cylinder?
Bleeding Your Clutch Check the fluid level in the master cylinder. Locate the bleed screw on the slave cylinder. Attach the hose to the bleed screw. Open the bleed screw on the slave cylinder. Have a friend press the clutch pedal in and hold it. Close the bleed screw. Have your friend release the clutch pedal.
Where do I find the bleed screw on my car?
You will find the bleed screw on the bottom or the underside of the slave cylinder. It looks like a bolt with a nozzle sticking out of it. If you have difficulty locating the slave cylinder or bleed screw, refer to the service manual for your vehicle.
How do you Bleed a slave cylinder in a car?
If you have difficulty locating the slave cylinder or bleed screw, refer to the service manual for your vehicle. Attach the hose to the bleed screw. Press a clear hose onto the slave cylinder bleed screw and place the other end in an empty soda bottle.
Bleeding Your Clutch Check the fluid level in the master cylinder. Locate the bleed screw on the slave cylinder. Attach the hose to the bleed screw. Open the bleed screw on the slave cylinder. Have a friend press the clutch pedal in and hold it. Close the bleed screw. Have your friend release the clutch pedal.
You will find the bleed screw on the bottom or the underside of the slave cylinder. It looks like a bolt with a nozzle sticking out of it. If you have difficulty locating the slave cylinder or bleed screw, refer to the service manual for your vehicle.
How do you close the bleed screw on a Jeep Cherokee?
Close the bleed screw. With your friend pressing the clutch pedal to the floor, use the open ended wrench to turn the bleed screw clockwise to tighten it again. This will once again seal the hydraulic clutch system, preventing air from getting sucked back into the system through the bleed screw.