How to install a 5R55 transmission in a car?
There is a simple way to fill the transmission before it is installed in your vehicle. Once the transmission is on the jack and ready for installation, fill it using the following procedure. Use only the supplied synthetic or OEM approved fluid. Install a funnel into the center speed sensor hole on top of the transmission. Pour in 8 quarts of ATF.
What kind of torque converter do I need for a 5R55?
Some 5R55 units use an 8-lug torque converter. In order to properly align the flex plate adapter, you will need to use a specific tool. Failure to properly align the flex plate adapter can result in vibration, leaks, or failure of the torque converter, pump, and bushings.
Are there any OEM 5R55S left in stock?
Only 4 left in stock – order soon. Only 4 left in stock – order s… In Stock. In Stock. In Stock. In Stock. In Stock. In Stock. Only 20 left in stock – order soon. Only 20 left in stock – order… Only 19 left in stock (more on the way).
How do you remove the rear fitting on a Ford 5R55?
1. Remove the front by squeezing the inner tabs. 2. Remove the middle fitting, if present, by using a pair of locking pliers to twist the fitting while pulling out. 3. Remove the rear fitting by squeezing and twisting the tabs. Be careful to not bend the fitting to the side. 4.
There is a simple way to fill the transmission before it is installed in your vehicle. Once the transmission is on the jack and ready for installation, fill it using the following procedure. Use only the supplied synthetic or OEM approved fluid. Install a funnel into the center speed sensor hole on top of the transmission. Pour in 8 quarts of ATF.
What’s the best way to start a Ford 5R55?
Make sure transmission fluid level is correct. With transmission in D position, moderately accelerate from stop to 50 mph (80 km/h). This allows the transmission to shift into 5th gear. Hold speed and throttle open and steady for a minimum of 15 seconds.
Some 5R55 units use an 8-lug torque converter. In order to properly align the flex plate adapter, you will need to use a specific tool. Failure to properly align the flex plate adapter can result in vibration, leaks, or failure of the torque converter, pump, and bushings.
How to do a Kam reset on a Ford 5R55?
Perform a KAM (Keep Alive Memory) Reset. A scan tool will be required to perform this procedure. Record and then erase Quick Test codes. Warm engine to normal operating temperature. Make sure transmission fluid level is correct. With transmission in D position, moderately accelerate from stop to 50 mph (80 km/h).
How do you install lifting hook on 5R55W / s?
If equipped with a 4.0L engine, tap the hole in the RH cylinder head in order to install the lifting hook. See Fig. 4. Use a 10 x 1.50 mm (0.06 in) tap to tap the hole. 10. If equipped with a 4.0L engine, install the lifting bracket in the previously tapped hole. See Fig. 5.
How do you remove an exhaust manifold from a 5R55W / s?
If equipped with a 4.0L engine, remove the exhaust manifold to Exhaust Gas Recirculation (EGR) valve tube. 9. If equipped with a 4.0L engine, tap the hole in the RH cylinder head in order to install the lifting hook. See Fig. 4.