How to fix an Eaton ultrashift transmission problem?
Tried resetting the computer with the key method and pulled the fuse. But wouldn’t start. Just a dash and flashing F. Then my driver remembered someone telling him awhile back to try tapping the x-y shifter on top the transmission. So he took a small pipe…tapped it a couple times…heard the transmission click a few times and stop.
How does the Eaton ultrashift work at idle?
Even at idle, it fully engages the clutch giving the driver ultimate control in challenging situations. The software is intelligent and fine tunes shift selection with changes in grade, weight and throttle to calculate the most efficient and effective shift points.
Why does my Eaton Fuller not shift gears?
My eaton fuller autoshift suddenly will not go into any gears in my driveway, just shows down arrows and R or 2 (flashing) when I try to go into any gear. When i have the truck off and turn key to start position and try to shift gears i can hear the transmission shifting successfully, however once the engine is running it will not shift gears.
Is the Eaton ultrashift compatible with cruise control?
Cruise Control The UltraShift is totally compatible with cruise control. If a shift is required while cruise control is active, cruise is temporarily interrupted while the shift is performed and then automatically resumed after the shift. Load-Based Shifting In Drive, the UltraShift will adapt to the changing conditions of the vehicle.
When did the Eaton ultrashift 10 speed come out?
Discussion in ‘ Trucks [ Eighteen Wheelers ] ‘ started by giannid, May 16, 2018 . We’ve got a 2010 International 8600 with an Eaton Ultrashift 10 speed.
Why does my ultrashift not go into gear?
It would not go into gear at times either up shifting or down shifting. We had to pull over on the side of the road and shut our battery switch off for 2 minutes to get the transmission to reset. This went on several times for about 24 hours.
What causes hard shifting on an Eaton transmission?
Linkage problems stem from worn connections or bushings, binding, improper adjustment, lack of lubrication on the joints or an obstruction which restricts free movement. To determine if the transmission itself is the cause of hard shifting, remove the shift lever or linkage from the top of the transmission.
Can a Eaton transmission be used in a commercial vehicle?
Current Eaton transmission models and specifications for use in commercial vehicle applications. Commercial vehicle topics including fuel efficiency, selecting manual or automated transmissions, Roadranger training, and customer success stories.
Is the Autoshift transmission based on a manual transmission?
The AutoShift transmission, based on the RT Series manual transmission, is an advanced shift-by-wire system that communicates with the engine utilizing the SAE-J1939 protocol for precise control of the engine and transmission functions.
How to check for an Eaton transmission error?
For all questions concerning inspection, removal, replacement, or adjustment procedures, refer to Eaton or OEM Service and Parts Literature. 1a. After activating the retrieval of codes, to read transmission errors via the Service Transmission light, observe the sequence of flashes exhibited by th e light.
What are the problems with an Eaton Fuller transmission?
Oil level too low or too high, wrong type of oil, or an operating angle of more than 12 degrees. 2. Operating consistently under 20 MPH. 3. High engine RPM. 4. Restricted air flow around transmission, due to the transmission being “boxed in” by frame rails, deck lids, fuel tanks and mounting brackets, or by a large bumper assembly.