How to change an oil sending unit on 2007-2014 Chevrolet?
How to change an oil sending unit on 2007-2014 Chevrolet, GMC, Silverado, Suburban, Escalade. Tahoe, – YouTube How to change an oil sending unit on 2007-2014 Chevrolet, GMC, Silverado, Suburban, Escalade.
Where is the oil pressure switch located in a GMC?
Using tool J41712 or equivalent, install the oil pressure sensor. Tighten the oil pressure sensor to 26 ft. lbs. (35 Nm) on 4.8L, 5.3L and 6.0L engines. Tighten the sensor to 22 ft. lbs. (30 Nm) on 8.1L engines. Connect the oil pressure sensor electrical connector. If necessary, install the engine sight shield.
How does an oil pressure sending unit work?
An oil pressure sending unit controls either the oil pressure light or gauge in your dashboard. When it detects oil pressure in the vehicle, a switch trips and either the light shuts off, or the gauge becomes active.
How do you remove an oil pressure sensor?
Removal & Install Procedure for 4.8L, 5.3L, 6.0L & 8.1L Engines If necessary, remove the engine sight shield. Disconnect the oil pressure sensor electrical connector. Using tool J41712 or equivalent, remove the oil pressure sensor. Apply sealant to the threads of the oil pressure sensor.
What is the oil pressure switch on a GMC Yukon?
Some of the company’s vehicles utilize a 5.3-liter V8 engine, including the GMC Yukon, GMC Sierra, Chevrolet Suburban and Chevrolet Silverado. The oil pressure sending unit, also called an oil pressure switch, is a component of the engine mechanical system. The oil pressure switch monitors changes in the oil pressure.
How to change an oil sending unit on 2007-2014 Chevrolet, GMC, Silverado, Suburban, Escalade. Tahoe, – YouTube How to change an oil sending unit on 2007-2014 Chevrolet, GMC, Silverado, Suburban, Escalade.
Where to replace the oil pressure sending unit?
If you suspect a problem, replace the oil pressure sending unit on your vehicle immediately. Park your vehicle in a safe location on level ground. Engage the parking brake. Open the hood. Disconnect the negative cable from the battery. Locate the oil pressure sending unit near the rear firewall of your vehicle.
Removal & Install Procedure for 4.8L, 5.3L, 6.0L & 8.1L Engines If necessary, remove the engine sight shield. Disconnect the oil pressure sensor electrical connector. Using tool J41712 or equivalent, remove the oil pressure sensor. Apply sealant to the threads of the oil pressure sensor.