How much does it cost to replace ignition coil on Saturn L300?
The ignition module or an ignition coil may fail causing the engine to misfire which can cause the Check Engine Light to illuminate or begin flashing. The average cost for a Saturn L300 Ignition Coil Replacement is between $356 -$424. Learn More
Why do I have a p0302 code on my OBD II?
The reason for a code P0302 being stored in your OBD II vehicle is that the powertrain control module (PCM) has detected an individual cylinder misfire. A P0302 specifically applies to the number 2 cylinder. Consult a reliable vehicle information source for the location of the number 2 cylinder for the vehicle in question.
What does p0302 mean on a fuel pump?
A code P0302 may mean that one or more of the following has happened: Defective ignition coil(s) Bad spark plug(s), spark plug wires, or spark plug boots. Faulty fuel injector(s) Malfunctioning fuel delivery system (fuel pump, fuel pump relay, fuel injectors, or fuel filter)
What do you need to know about a p0302 misfire?
Malfunctioning fuel delivery system (fuel pump, fuel pump relay, fuel injectors, or fuel filter) A diagnostic scanner, digital volt/ohmmeter (DVOM), and a reliable vehicle information source will be required to diagnose a stored (or pending) code P0302.
The reason for a code P0302 being stored in your OBD II vehicle is that the powertrain control module (PCM) has detected an individual cylinder misfire. A P0302 specifically applies to the number 2 cylinder. Consult a reliable vehicle information source for the location of the number 2 cylinder for the vehicle in question.
A code P0302 may mean that one or more of the following has happened: Defective ignition coil(s) Bad spark plug(s), spark plug wires, or spark plug boots. Faulty fuel injector(s) Malfunctioning fuel delivery system (fuel pump, fuel pump relay, fuel injectors, or fuel filter)
Malfunctioning fuel delivery system (fuel pump, fuel pump relay, fuel injectors, or fuel filter) A diagnostic scanner, digital volt/ohmmeter (DVOM), and a reliable vehicle information source will be required to diagnose a stored (or pending) code P0302.
When did the recall on the Saturn come out?
GM will notify owners, and dealers will inspect the vehicle to see if the key can be pulled out when the ignition is off. If it can, dealers will replace the ignition cylinder and keys, free of charge. The recall began in October 2014. Owners may contact Saturn customer service at 1-800-553-6000.
What to do if your MSD Ignition switch is not working?
If you are using the 2-Pin Magnetic Pickup of the MSD to trigger the ignition, follow these steps. Make sure the ignition switch is in the Off position. Remove the coil wire from the distributor cap and position the terminal so it is approximately 1/2″ from a good ground. Disconnect the MSD Magnetic Pickup connector from the distributor.
What should I do if my car ignition is not working?
Tap the White wire to ground several times. Each time the wire is pulled away from ground a spark should jump from the coil wire to ground. If spark is present, the ignition is working properly. Inspect all of the wiring. Substitute another coil and test again. If there is now spark, the coil is at fault.