How much does it cost to replace a solenoid valve on a 2002 Nissan Altima?
Nissan Altima Variable Valve Timing (VVT) Solenoid Replacement costs $317 on average.
| Car | Service | Estimate |
|---|---|---|
| 2002 Nissan AltimaV6-3.5L | Service typeVariable Valve Timing (VVT) Solenoid Replacement | Estimate$489.15 |
| 2010 Nissan AltimaV6-3.5L | Service typeVariable Valve Timing (VVT) Solenoid Replacement | Estimate$564.09 |
What causes the p0011 code on a Nissan?
Tech notes Since the Intake valve timing control solenoid valve uses oil flow to control timing, dirty oil can cause the valve to stuck open or close. When there is a gap between angle of target and phase-control angle degree, the valve will stop working and the ECM will trigger the P0011 code.
What does the OBDII code for Nissan Altima mean?
P0011 is a generic OBDII code. This means that it has the same definition for the Nissan Altima as it does on any other vehicle. VVT changes the frequency and distribution of gases entering and exiting the combustion chamber. It allows the engine to act as though it has different camshaft profiles…
When does the ECM trigger the p0011 code?
When there is a gap between angle of target and phase-control angle degree, the valve will stop working and the ECM will trigger the P0011 code. This mechanism hydraulically controls cam phases continuously with the fixed operating angle of the intake valve.
What causes a Nissan Altima to idle low?
When the timing is too far advanced, it can really cause some issues with the motor. Here are some of the typical symptoms of P0011 in the Nissan Altima: Poor Idle Quality – If the camshaft actuator fails while giving the engine aggressive valve timing, it’ll idle roughly.
What does engine code p0011 mean?
A P0011 code refers to the VVT (variable valve timing) or VCT (variable camshaft timing) components and the car’s PCM (powertrain control module) or ECM (engine control module). VVT is a technology used in the engine to allow it to get greater power or efficiency at different running points.
What does diagnostic trouble code p0011 mean?
P0011 is a diagnostic trouble code (DTC) for “Camshaft Position A – Timing Over-Advanced or System Performance (Bank 1)”. This can happen for multiple reasons and a mechanic needs to diagnose the specific cause for this code to be triggered in your situation.
What is a code po420 on Nissan Altima?
The P0420 code in a Nissan Altima will often be thrown one of your oxygen sensors are not functioning properly. Typically, the code will be triggered by the upstream oxygen sensor (before the converter). There aren’t usually any drivability issues associated with P0420.
What is this code p0011?
- or valve issues of the camshaft oil control valve for the bank 1 intake camshaft.
- Check the engine for it to be full of clean engine oil with the correct viscosity.
- The technician will scan and document the codes received and view the freeze frame data to see when the code was set.