How much does it cost to install cruise control on a Toyota Corolla?
I installed an aftermarket cruise control on my 2008 Corolla with an automatic transmission. It only cost $38 USD for the parts and was a fairly simple install. Note that this procedure applies to all GEN 9 Corollas equipped with an automatic transmission and a “drive by wire” throttle.
How to troubleshoot cruise control on a Toyota?
Look at the top of the clutch and brake pedals for the switch, and see if anything is broken/loose. Press button in on stalk – observe green light. Tap stalk down to set speed. Tap up or down to adjust set speed. Pull stalk toward you to cancel. Must be about 25 mph to work. Thanks for the suggestions. The car has an auto trans.
How do you remove ferrule from Toyota cruise control?
If you have some understanding of Mate Lock connectors, then it is easier to remove the ferrule. There is a metal spring tab that locks the ferrule into the plastic connector (see the red arrow in step 8 below). To release the ferrule, you need to push the barb down, while pulling the wire out of the connector.
Where are the cruise control screws located on a Toyota?
Use a T-30 Torx driver bit. The screws are located on either side of the steering wheel. Pull the screws out. I used a needle nose pliers to pull the screws out. It was a bit hard to grip the heads of the Torx screws with the needle nose pliers and it took a bit of wiggling to get them out.
Is there a C package on a Toyota Corolla?
The C package is available on all base CE Corollas. If you order the LE model, all this stuff is standard, including 4 wheel disk brakes. Nearly all Corollas sold are automatic; the stick shift customers seem to want a bare bones car, and usually forego the C package.
How to install cruise control on a Toyota Auris?
Here is how to install Cruise Control to your Auris… Found this instruction on Toyota Owner’s Club Russia -forum, special thanks to Andron, who took the pictures and wrote the russian text! I made some improvements and posted it here, enjoy… You’re gonna need two parts: (You can see the part numbers on the pictures)
What do I need to install a cruise control switch?
Place the above connector, side by side with the connector from the new cruise control switch. You need to transfer the green wire to the connector on the cruise control switch. 6. Remove the white wire lock from both connectors.
Can you install cruise control on a 4ZZ-FE engine?
You cannot install Cruise Control if your car has 4ZZ-FE -engine!! So if you can just buy the cruise control from Toyota and a cable and then conenct them up?? That’s correct! This then begs the question – KINGO (parts king) how much for the 2 bits listed in the first post? Will this work for 1.4 D-4D Auris with Manual Transmission?
Where can I get a new Toyota Corolla?
Me llaman el vendedor bailarin, asi que veras unos videos de mi bailando tambien 🙂 Fun to watch videos of dancing & awesome cars. if you ever need a new Toyota or used car of any brand, i’m here in Cleveland, OH to help you out.