How long does it take to build up the pressure in a Peugeot 5008?
-The pressure builds up to some 50 bars in a matter of 3 to 4 seconds. This normally takes less than a second. The below works concerned a Peugeot 5008 equipped with a turbo-charged EP6 engine. 1- Remove all air hoses and the battery if needed. 4- Disconnect the electrical connector and the low pressure fuel tube.
How does a Peugeot 1.4 HDi fuel pump work?
If you leave it parked facing steeply downhill you may find that the fuel will leak out where the problem is. If you leave it parked facing steeply downhill you may find that the fuel will leak out where the problem is. I had the fuel “pump” out. Turns out it is not a pump ! Well, not an electrical one and I dont know how it works – any body know.
What should the pressure be on a Fuel Pump HPFP?
It remains low at 4 to 5 bars, i.e. the pressure generated by the fuel pump in your fuel tank (picture to the right). It could fluctuate up to 7 bars and drop back to 4 or 5. The HPFP did not obey the instruction which denotes a failure. -Plug your scanner and go straight away to the measured common rail pressure.
Can you replace the HPFP in a Peugeot 5008?
A minimum of experience in DIY mechanics is required. The fuel circuit would need to be bled as explained in the pictorial. Replace this HPFP of a Direct Injection Petrol Engine. The below works occurred on a Peugeot 5008 equipped with an EP6 direct injection and turbocharged engine. HPFP removal on other engines is pretty similar to this case.
-The pressure builds up to some 50 bars in a matter of 3 to 4 seconds. This normally takes less than a second. The below works concerned a Peugeot 5008 equipped with a turbo-charged EP6 engine. 1- Remove all air hoses and the battery if needed. 4- Disconnect the electrical connector and the low pressure fuel tube.
It remains low at 4 to 5 bars, i.e. the pressure generated by the fuel pump in your fuel tank (picture to the right). It could fluctuate up to 7 bars and drop back to 4 or 5. The HPFP did not obey the instruction which denotes a failure. -Plug your scanner and go straight away to the measured common rail pressure.
A minimum of experience in DIY mechanics is required. The fuel circuit would need to be bled as explained in the pictorial. Replace this HPFP of a Direct Injection Petrol Engine. The below works occurred on a Peugeot 5008 equipped with an EP6 direct injection and turbocharged engine. HPFP removal on other engines is pretty similar to this case.
How do you replace a high pressure fuel tube?
11- You also need to replace the high pressure fuel tube. 14- Push the HPFP in its place while aligning it with the camshaft drive. 17- Plug the scanner and read the common rail pressure. Inspect your vehicle for leaks and keep checking the scanner for a few minutes to make sure the pressure does not drop i.e. there are no leaks.