How does the ignition control module work in a car?

How does the ignition control module work in a car?

Basic Theory: How The Ignition Control Module Works. In a nutshell, the ignition control module’s job is to create a Switching signal for the ignition coils that are sitting on top of it. It’s this Switching signal that makes the ignition coils create spark.

How to replace Ignition Control Module on LT1 Firebird?

This video shows how to replace the Ignition Control Module on a 4th Generation Firebird Trans-Am equipped with LT1 Engine. These steps are similar for all other 4th generation Firebirds and Camaros as long as they are equipped with an LT1 Engine. Loading…

How to test the ignition module and crank sensor?

So, if you’re driving a Chevy, a Buick, a Pontiac, or an Oldsmobile with either one of these engines, not forgetting the Isuzu Rodeo or Trooper, this ‘How To Test The Ignition Module’ and 7X (3X) article applies. There are two other articles that may help:

Is there a spark in the ignition module?

There is no spark coming out of any of the ignition coils sitting on top of the ignition module. You may have taken your ignition control module (ICM) to Auto Zone to test it and the friendly boys in orange say it’s good, yet the vehicle will not start (all major auto parts stores such as O’Reilly, Pepboys, etc., test ignition modules for free).

Where is the ignition module located?

On some cars, the ignition module may be housed on or inside the distributor. In other cases, it may be a standalone unit, or it may be integrated into the ignition coil assembly. The ignition module is easy to access and replace on some vehicles, but on others, it’s buried deep inside the engine compartment.

What happens if you have a bad ignition control module?

A faulty ignition control module can cause a number of problems. 1. Check engine light is on: The ECM monitors all parts of the vehicle that could affect emissions. This includes the ignition system. If it determines the ignition module has caused a problem with the system, it will turn on the check engine light.

How does the crank sensor control the ignition module?

The ignition module starts to turn On and Off the ignition coils in their proper firing order to create spark, after the crank signal arrives. This On/Off action is the Switching signal referred to above. Under 400 RPM’s, the ignition control module controls spark timing without the help of the fuel injection computer.

There is no spark coming out of any of the ignition coils sitting on top of the ignition module. You may have taken your ignition control module (ICM) to Auto Zone to test it and the friendly boys in orange say it’s good, yet the vehicle will not start (all major auto parts stores such as O’Reilly, Pepboys, etc., test ignition modules for free).