How do you turn off the door ajar on a Ford Explorer?
There is not an official way to disable the door ajar alarm on the Ford Explorer. What You can do is open the dash board of the car, and locate the module that controls it and pull it out.
Why wont my interior car lights turn off?
The likely cause of a dome light not turning off is either the dashboard light control knob being activated accidentally or a broken door switch. You can remove the wire from the door switch, if you are able to access the backside of the switch. The wire pulls off of the switch easily.
What causes the door ajar warning light to stay on?
However, a fault in either the electrical or mechanical components can cause the door ajar warning light to remain on when the doors are closed, and possibly cause the interior lights to remain on. Can I drive with the door ajar warning light on?
Where is the ajar light on my car?
A door ajar sensor is an electronic component that is equipped to each of your car doors. It sends signals to your car’s computer. It signals your car computer whether the door is open or closed. What is a car ajar light? Your car ajar light is often located on the dashboard of your vehicle.
How to disable the door ajar light on a Ford Explorer?
Why Is The Door Ajar Light Still On Even After All Doors Are Firmly Closed? 1 Spray a WD-40 lubricant liberally into the door latch. 2 Open and close the door firmly a couple of times to help work the grease in the mechanism. 3 Replace defective door switches 4 Fix structural causes, if any.
What to do if your car door is ajar?
Open the doors one by one to locate the faulty door. Check for the door that opens up without the alarm and the courtesy light. That is your culprit. Remove the panel on the door or the trunk depending on which is faulty. Here is a little guide on how to remove the panel safely.