How do you take the front bumper off a Jeep Cherokee?
Start by disconnecting the wiring to any fog lights that you may have on the bumper. Then using a T50 Torx remove the two bolts on underside of the passenger side of the bumper that hold the vacuum ball to the bumper. The easiest way to remove the bumper is to remove the stock bumper with the brackets still attached.
Do you need a front bumper for a jeep?
Adding a new front bumper to your Jeep does much more than simply change the look of your vehicle. A heavy duty off-road bumper can offer additional front recovery points, auxiliary light mounting options, and winch mounting solutions.
How to fix front bumper on Jeep wrangler trail force?
Slide the hardware over the studs, make sure you’re using a washer and a lock washer, and then thread your nut. Repeat that step on the other side. Thread in the one bolt into this top hole here. Grab your 18-millimeter socket and tighten it down. Thread your washer and lock washer over the stud on the bottom.
How do you remove a bumper cover from a car?
Remove the screws behind the tail light inside your trunk. There will also be screws and snaps on top of the bumper cover (two underneath the tail light). Remove the screws from under panel skirt attached to the bumper cover (if necessary). You’ll need a screwdriver to do this. On some cars, there may also be snaps.
What causes bump steer on a Jeep Wrangler?
Bump steer occurs when the vehicle darts right or left after hitting a bump in the road, and is easier to identify through improperly installed suspension kits, or broken/damaged steering components. Nor should it be confused with a vibrations felt at higher speeds, as this is normally caused by an improperly aligned vehicle.
How to remove front bumper on Jeep Wrangler JK?
In today’s Quadratec Academy lesson, we show you how to remove your stock front bumper on your 2007-2017 Jeep Wrangler JK. This will only take you a few minutes and once it’s off you are ready to put on that upgraded bumper you just bought. Quadratec is your source for Everything Jeep®!
How do you replace the front bumper on a car?
5) Use a plastic automotive interior wedge or similar and lever back the bottom of the wheel arch fender. Apply increasing but consistant pressure until you pop off the first couple of plastic push rivots. They are pretty hard to get off. The first 4 are green and are less likely to snap.
Is there an aftermarket bumper for a JK?
These days, there are plenty of aftermarket bumper options which serve to add strength, while helping increase impact resistance, durability and overall safety over the factory version. Many aftermarket bumpers also provide winch mounting solutions, auxiliary light mount points, modular options and much more.
Can a factory bumper be removed from a quadratec?
Many aftermarket bumpers also provide winch mounting solutions, auxiliary light mount points, modular options and much more. However, getting that factory bumper off does give some enthusiasts pause. So we address that aspect in today’s Quadratec Academy lesson. If playback doesn’t begin shortly, try restarting your device.