How do you reset the TPMS light on a 2007 Nissan Versa?
With the vehicle off, turn the key to the “On” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh.
When to turn on TPMs on Nissan Versa?
● The TPMS does not monitor the tire pressure of the spare tire. ● The TPMS will activate only when the vehicle is driven at speeds above 16 mph (25 km/h). Also, this system may not detect a sudden drop in tire pressure (for example a flat tire while driving).
When do I need to Reset my TPMS system?
NOTE: To determine the appropriate reset procedure, refer to TPMS RESET INDEX. Only vehicles listed in this index have a TPMS reset. NOTE: Whenever a wheel is changed or replaced, or whenever vehicle has been loaded, the TPM system needs to be reset. See Tire Pressure Monitor System Reset.
How to reset TPMS in Volkswagen Vas 5051b?
NOTE: If unapproved wheel/tire combinations are installed, a 2nd wheel set must be learned. To perform this procedure, Volkswagen VAS 5051B is required. 1. Read out tire pressure sensor IDs before installation. 2. Switch TPMS to wheel set 2. 3. Enter needed specified tire pressures and sensor IDs into system.
How to set tire pressure in Volkswagen TPMS?
1. Set the tire pressure of all wheels to specified pressure. 2. With vehicle stopped and parking brake applied, turn ignition switch to ON position. 3. Press SET button (located near gear shift) until an audio signal is heard. See Fig. 10. The signal confirms basic setting. 1. Set the tire pressure of all wheels to specified pressure. 2.
● The TPMS does not monitor the tire pressure of the spare tire. ● The TPMS will activate only when the vehicle is driven at speeds above 16 mph (25 km/h). Also, this system may not detect a sudden drop in tire pressure (for example a flat tire while driving).
How often does the tire pressure beep on a Nissan Versa?
If the tire is over-inflated more than approximately 4 psi (30 kPa), the horn beeps and the hazard indicators flash 3 times. To correct the pressure, push the core of the valve stem on the tire briefly to release pressure. When the pressure reaches the designated pressure, the horn beeps once.
How to relearn the Nissan TPMS reset instruction?
Re‐scan each sensor. Drive the vehicle above 30mph for at least 10 minutes and monitor the low tire pressure monitor to ensure it does not blink. If you see an error on the screen while performing an OBDII Relearn, check to make sure that the vehicle is in the ON position (not ACC).
How to reset the wrench indicator on a Nissan Versa?
Tutorial on how to reset the Wrench Indicator, Oil Reset, and TPMS Reset on Nissan Versa. This tutorial will also work in Nissan Tiida, Nissan Latio, Nissan Note, Nissan Almera from year 2006-2007-2008-2009-2010-2011-2012-2013-2014-2015-2016-2017-2018-2019-2020. Turn the ignition to the “RUN” position.