How do you remove upper ball joints from control arms?
Remove the nut on the bottom of the upper ball joint using a wrench. Separate the ball joint using the ball joint separator tool. Insert the tool between the spindle and the upper control arm and hit it with a hammer until it comes loose from the spindle.
Should I replace control arm or ball joint?
Both the lower and upper control arms have a ball joint, although the upper ball joint is often smaller. There are several reasons why a control arm needs to be replaced. The most common reason is when a ball joint wears out, and it cannot be replaced separately. Often a ball joint comes with a control arm as one unit.
Can you just replace the ball joint?
Ball joint replacement is not straightforward, as they can be very tricky to access and install – especially with age and rust. On some cars, the ball joint is integrated into the control arm. If you’re not familiar with the suspension and wheel assembly, it’s best to visit a garage for a professional check.
How are the rivets removed to replace the ball joint?
Chisel off the head of the rivet using the air hammer. Insert the pointed tip into the air hammer. Place the tip of the air hammer attachment onto the area where the rivet was previously, then pull the trigger and hammer the rivet through the lower control arm until the ball joint can be pulled out of the arm freely.
How to replace upper control arm ball joint?
Upper Ball Joint Replacement. This video will show you how to replace the Upper Control Arm Ball Joint on a Chevy Trailblazer, GMC Envoy, etc. Replacing a ball joint is fast and easy and can be done with basic hand tools and a ball joint press you can rent for free at your local parts store.
How do you remove an upper control arm?
Position a floor jack under the lower ball joint or control arm to relieve downward pressure on the suspension components. This will enable you to remove the upper control arm without pressure bearing down on the arm. You might need to remove any small wiring or brake flex hose clips to free up the arm for removal.
How to replace lower ball joint on Chevy Silverado?
This video outlines the complete process of removal and replacement of the upper control arm and lower ball joint on a 2008 Chevrolet Silverado 2500 HD 4X4 with torsion bar front suspension. The process is similar on many GM trucks and includes tips and tricks to help make the job easy and do it right. The entire process was unedited for time.
Can a ball joint be replaced on a Mercedes Benz?
Some of the Mercedes-Benz upper control arms have the ball joint as part of the control and it can not be replaced. Mercedes-Benz improved the design over the years allowing the upper ball joint to be easily removed from the control arm by removing three bolts.
https://www.youtube.com/watch?v=BSMoEiXjUJs