How do you remove the rear drive shaft on a Subaru?
Slide the drive shaft out of the gear box, being careful not to damage the oil seal or the splines on the output shaft. Remove the drive shaft from under the car. Place the jack under the rear of the car and raise it off the jack stands. Remove the jack stands and lower the car to the ground.
How do you remove a drive shaft and install?
Wear protective eyewear and gloves before you begin.
- Mark the Driveshaft. Mark the driveshaft orientation before beginning.
- Remove Driveshaft Bolts. Remove the shaft differential flange mounting bolts.
- Remove Driveshaft Flange.
- Remove Driveshaft.
- Check U joints.
- Reinstall Driveshaft.
- Reinstall Flange Bolts.
What does a bad u-joint sound like?
A bad u-joint can cause a clunking sound or jerkiness while driving, particularly when letting off of and pressing the accelerator. Then, shift into drive. If the vehicle makes a clunking sound, or you can feel it knock one time after engagement, a u-joint is likely the culprit.
What does a bad drive shaft bearing sound like?
Abnormal Noises If the bushing or bearing that supports the driveshaft or the driveshaft U-joints wear out or fail, they can interfere with the driveshaft’s ability to rotate correctly. This may result in unusual rattling, clunking, scraping, or even squeaking sounds from underneath the vehicle.
Can you drive without a drive shaft?
You can drive the vehicle indefinitely in this mode with one driveshaft removed. Never drive with one driveshaft removed unless the CDL is locked; you can burn up the viscous coupler in vehicles so equiped, but also the vehicle will roll even if the transmission is Park (unless the Emergency brake is engaged).
What causes drive shaft failure?
Improper stiffness matching between the left and right smooth shafts, which results in a larger torque transmitted to the right spline, is the root cause of the drive shaft failure.
Can you remove the rear drive shaft and still drive?
Remove the damaged drive shaft and lock the center differential. This will allow the transfer box to transfer power to the front or rear drive shaft. You will be able to safely drive the vehicle in front wheel drive or rear wheel drive mode. A few warning lamps from the ETC system might start flashing but don’t panic.
Can you drive an AWD without rear driveshaft?
Yes, you can if you remove the rear driveshaft. Basically you’d be in front wheel drive mode. Assuming you mean the u-bolt on the rear of the driveshaft It’s not going to hurt anything.
How do you remove a rear drive shaft?
The rear-drive shaft uses a slip yoke in the front to engage the gear box and a bolt-on flange in the rear where it joins the rear differential. Removal of the shaft can be done with basic tools that most home mechanics have in the garage already. Place the transmission of your car in neutral.
What’s the best way to replace a driveshaft support?
Step 1: Prepare the vehicle for working. Use a floor jack to raise the vehicle to a height that will allow easy access to the driveshaft while using your tools. Jack one wheel at a time and place jack stands underneath solid mounts for support. Once the vehicle is secured make sure you have enough light to see underneath the vehicle.
How do you replace a drive shaft in a Subaru Outback?
Took the 2 bolts out of the exhaust hanger at the transmission and let it hang down a bit (I have the OBX stainless header set which has flex joints, so it might work better than stock exhaust for that). I did have to cut the nut off one of the bolts between the shaft and diff, as it was rounded, but the other 3 came out.
How do you remove a front drive support bearing?
The front driveshaft is going to be attached solid inside the output shaft supports. In order to remove the driveshaft, you’ll need a rubber or plastic tipped hammer. On the front of the driveshaft is a welding mark that is solid and is the best place to hit with the hammer to loosen the driveshaft.