How do you remove a filter from a fuel pump?
Dismantle the head from the filter. Using a flat screwdriver, lift the lid a little bit and pull the filter away from the head to clear the latch (FIG 8). Do the same to the remaining latches to completely detach the filter from the head. 15. Unplug the terminal lug shown in FIG 9 by pushing the detent and pulling out the lug. 16.
How do you unplug a fuel pump?
IMPORTANT: Cover the fuel tank opening to prevent dust and other foreign matter from falling into the fuel tank. 11. Unplug the fuel pump and the lever sender connectors (FIG 5). Each connector has a standard snap-on latch. Just press the latch and pull out the connectors.
Where is the fuel pump located in a car?
If you have a petrol engine with an electronic fuel pump, the fuel pump is often not very expensive. The expensive part is letting a mechanic replace the pump. The pump is often located inside the fuel tank, which means that there is a cover to reach it from under the back seat if you are lucky.
What’s the best way to check your fuel pump?
Use a short piece of rubber hose on the filter inlet. Blow through the filter inlet, paying attention to the resistance, which should be minimal. Inspect the screen for debris and replace the filter if necessary by blowing through the outlet side of filter into a white rag or towel. Get a fuel pressure gauge.
What is the easiest way to remove the fuel pump?
- Never crawl under a vehicle supported by an hydraulic jack. Always use axle stands or ramps under wheels.
- You will need to siphon off the majority of your fuel.
- 25 litre plastic container open on one side as per picture.
When is it time to replace your fuel pump?
A high quality, OEM fuel pump can last indefinitely. However, as with any electro-mechanical component, a fuel pump will eventually degrade and fail. If it fails to produce adequate pressure or completely quits operating, it will need to be replaced.
How expensive is it to replace a fuel pump?
The average cost for replacing a fuel pump in a vehicle is around $500. But wait! There are several factors that play a role in determining the actual cost.
How do you replace the fuel pump?
Here’s how to replace the fuel pump in a gas tank for cars with a carburetor engine. Disconnect the ground cable (it’s usually black) from the battery’s negative (-) terminal. Examine the fuel line from the gas tank and replace it if it’s cracked or leaky. Release the gas tank pressure according to the instructions in the car’s service manual.