How do you loosen windshield wiper arms?
Steps
- Turn the windshield wiper switch off.
- Follow the wiper arm away from the wiper blade to its base.
- Pry up the plastic dust cap covering the nut.
- Select a socket sized to fit the hex nut.
- Set the ratchet to allow it to tighten the nut.
- Tighten the nut.
- Test the wipers.
How do you adjust the blades on a windshield wiper?
Adjust Blade Alignment. 1. Use two sets of pliers to bend the wiper arm back into position if the wiper arm has been twisted and the blades are not perpendicular to the windshield. Hold the wiper arm with one set of pliers to anchor it and use the other set to twist it so the wiper is perpendicular to the windshield.
What to do when your windshield wiper is not working?
Turn the ignition to accessory mode and make sure the wiper switch is off. Turn the ignition switch off and remove the keys. The wiper motor is now in its parked position, even though the wiper arms may not be properly aligned. Access the base of the wiper arms.
How can I tighten the retaining nut on my windshield wiper?
Make sure that your wiper arm is in the correct resting position on the windshield (it should land on the same mark you made with the original wiper). Gently tap the arm down onto the shaft. It is ideal to use a tool that will not scratch your new wiper arm. Rubber mallets work well for this. Clean the threads for the retaining nut.
How do you change the wipers on a car?
Replace the retaining nut and tighten it. Repeat this procedure for the other wiper arm if needed. Insert the ignition key and turn it to the accessory position. Turn on the windshield wipers and allow them to cycle, then turn the wipers off and let the wiper motor return to the park position.
Adjust Blade Alignment. 1. Use two sets of pliers to bend the wiper arm back into position if the wiper arm has been twisted and the blades are not perpendicular to the windshield. Hold the wiper arm with one set of pliers to anchor it and use the other set to twist it so the wiper is perpendicular to the windshield.
Turn the ignition to accessory mode and make sure the wiper switch is off. Turn the ignition switch off and remove the keys. The wiper motor is now in its parked position, even though the wiper arms may not be properly aligned. Access the base of the wiper arms.
How to re-time the windshield wiper on a Honda Accord?
Adjust the windshield wipers back into their normal down position against the the lower edge of the windshield. Be careful where you place the nuts while re-timing the windshield wipers. If you misplace them, you’ll have to buy more nuts of the same size to replace them. “Honda Accord Repair Manual 2003-2005”; Robert Maddox, John H. Haynes; 2005
Where is the retaining nut on a windshield wiper?
Access the base of the wiper arms. You may have to open the hood or remove the plastic cowling in front of the windshield to get to the base of the arms. Locate the retaining nut at the bottom of the wiper arm. Some models will have a protective plastic cap covering the nut.
https://www.youtube.com/watch?v=4YhpeoZoKu8