How do you line up front fenders on a car?
These two fender bolts allow the bottom of the fender to move in and out. Together with the one above the door hinge, these will let you line up the rear edge of the front fender with the front edge of the door and the rocker panel.
Where do you put shims on a car fender?
The adjustment is actually made using slots in the fender lip. The shims, in this case, simply prevent you from drawing up and bowing out the lower part of the fender.
How is the door aligned with the rocker panel?
The leading edge of the door then needs to be even with the leading edge of the rocker. With the door aligned with the rocker panel, the gap between the door and the quarter-panel has now been established. If the door to quarter gap isn’t to your liking, then some metalwork will be required to tweak that gap.
How do you adjust the front fender on a hot rod?
The adjustment is actually made using slots in the fender lip. The shims, in this case, simply prevent you from drawing up and bowing out the lower part of the fender. Shims under the bolt on top will raise or lower the rear of the fender, while shimming the one facing forward will move the fender fore and aft.
Where are the quarter panels on a car?
Quarter Panel Location Your car has two quarter panels, both of which are located at the rear of your vehicle. Your car’s rear quarter panels can be found right between your rear door and the trunk or bed (depending on whether you have a standard car or a truck).
What’s the purpose of the Fender on a car?
Fenders are, essentially, the frame of the wheel well. Their main purpose is to catch “road spray” and prevent tires from throwing dirt and debris at other vehicles and pedestrians. Just like bumpers, though, fenders often absorb a lot of the force of any impact. Side collisions, in particular, tend to damage fenders.
Can a damaged auto body panel be straightened?
Slightly damaged auto body panels can be straightened. Auto body panels damaged beyond your collision repair skills can be replaced. Either way there is a solution open to you. The tools you will need are… The basic tools for doing bodywork include:
How do you fix a dent in a car body panel?
You can then hammer out the dent using the slide to return the sheet metal back to its original position. You may need to tap the sheet metal back in a little if you accidentally hammer it out too far. The slide hammer is then moved over to the next rod where it is again hammered out to undo the effects of the impact.