How do you change a blower motor on a Volvo?
Demate the two power cable connectors on top of the bracket, then remove them by squeezing the tabs that hold the connector to the mounting hole. NOTE: you may find it helpful to put the carpet back down if it was not removed fully from vehicle at this time.
When did the first Volvo XC90 come out?
In this article, we consider the first-generation Volvo XC90 after a facelift, produced from 2008 to 2014. Here you will find fuse box diagrams of Volvo XC90 2008, 2009, 2010, 2011, 2012, 2013 and 2014, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout).
Where are the fuses on a Volvo XC90?
Fuses are located inside the access panel on the edge of the dashboard, on the driver’s side. These fuses in the cargo area are located behind the panel on the driver’s side of the cargo compartment. Parking heater (option).
How do you remove weatherstrip from Volvo blower motor?
Step 24: Using weatherstrip removal tool or similar, remove all round cable clips from CEM bracket; the white/gray connector at the top must be demated using the lever provided, then slipped off its bracket by pushing down on the black clip holding it in and sliding it to the left.
How long does it take to replace a blower motor?
There is no way to remove the blower otherwise (short of tearing the dashboard out of the car completely). Time: 4-6 hours for the first-timer. Attached are the VIDA printouts for each job.
What’s the best way to replace a blower?
Step 32: Replace blower, holding it at approximately 15-degrees anticlockwise from straight up and down, then turn clockwise so tool is straight up and down. Attempt to pull blower straight away from mounting point to check that all four locking lugs have engaged.