How do you adjust the clutch on a VW Jetta?
After you pump the clutch a few times, the clutch will adjust. Replace the clutch cable of the VW Jetta with one that you adjust manually, rather than relying on the stock self-adjusting cable.
Where is the clutch cable on a VW Beetle?
Jack the rear of the VW Beetle, remove the left rear wheel, and look for the housing of the transmission. Attached to the housing is the clutch cable and a nut for the cable. Turn this nut to adjust the clutch, and test the results. Locate the clutch adjustment mechanism in the engine bay of the car.
Where is the clutch cable adjuster on a Volkswagen?
Locate the clutch cable adjuster in the engine compartment. The cable adjuster, which consists of a white plastic adjuster and steel locknut, is on top of the transaxle on the left or driver’s side of the engine compartment.
How do you tighten the cable on a clutch?
Tighten the cable adjuster with your fingers until there is the specified amount of clutch free play. In 1985 and later models, insert the 15/32-inch spacer between the plastic flange of the adjuster and the transaxle housing beneath it. Turn the adjuster counterclockwise until the flange is snug on the spacer, and then tighten the locknut.
How big is the clutch on a Volkswagen Golf?
The specification for free play in the Golf clutch is 5/8 inch or 15mm. If the free play is greater than this it requires adjustment. Push the clutch pedal in and release it several times before making adjustments. Loosen the clutch cable locknut with a wrench.
Where is the clutch cable on a Volkswagen Golf?
Look for the white plastic locknut atop the transaxle just to the left of the battery as you are looking from the front of the vehicle. The clutch cable leads from the clutch cable adjuster through the firewall to the clutch cable. Turn off the engine and set the parking brake.
Where is the clutch fluid in a VW Passat?
Check the level of the clutch fluid in the reservoir in the VW Passat if the clutch isn’t responding as it should. Fill the reservoir, which is located in the rear left of the engine bay, and pump the clutch pedal a few times to restore the pressure in the lines.