How do you adjust a 727 kick down cable?
The best way to adjust the kickdown is to have someone sitting in the car with the gas pedal all the way down like if you were to floor it. Then with you under the hood adjust the kickdown so it is all the way engaged when the pedal is floored.
How do you adjust a Lokar kickdown cable?
Slide the kickdown cable end stop onto the inner wire. Move the throttle to wide open and hold it there while pulling the kickdown inner wire as tight as possible. Slide the cable end stop up against the kickdown throttle body fitting and tighten the set screw using the supplied 5/64″ Allen wrench.
How does kick down work in automatic transmission?
A current is applied to the kick-down solenoid, when the automatic transmission switches to the kick-down mode. Then the kick-down valve opens and pressure applies to 1-2 and 3-4 gears. When the gas pedal is depressed, the solenoid gets cut from current, but the valve stays open.
Where is the kick down Cable on a fuel injected car?
The kick down cable is mounted to the carburetor, or, in the case of fuel injected vehicles, the throttle body. It runs from the butterfly arm on the carburetor down to the side of the transmission, where it attaches to an arm that allows the transmission to shift gears.
How to adjust the kickdown cable on a Turbo 350?
The coordination of these two cables is essential for proper operation of the kickdown function. You can adjust the kickdown cable with the aid of a helper and basic automotive knowledge.
How do you adjust the shift linkage on an automatic transmission?
First, loosen the shift shaft adjustment nut when the transaxle is in the 1st gear. Push the stick shift lever forward and then to the left. Hold it firmly in the 1st gear. You could ask your helper to hold it in position. While the shifter is in 1st gear, tighten the shift tube nuts using two wrenches.