How do I setup my tp-link MR3020?

How do I setup my tp-link MR3020?

How to Configure the Access Point Mode on the TL-MR3020 and TL-MR3040

1. Go to Quick Setup-> Click Next.
2. Select AP-> Click Next.
3. Customize your wireless name (SSID) and password.
4. Click: Reboot, and wait until it goes to 100%

How do I setup my tp-link portable router?

How to Configure the Hotspot Router Mode on the TL-WR802N?

1. Use the default Wi-Fi Name and Password printed on the Wi-Fi Info Card to connect to the router.
2. Launch a web browser and type http://tplinkwifi.net into the address bar.
3. Click Quick Setup on the left panel, and click Next to start configuring the router.

How do I reset my TL-MR3020?

To reset the TP-LINK TL-MR3020 to its default settings, you have to do the following steps:

1. Turn on router.
2. Press WPS/RESET button and hold for at least 10 seconds.
3. Device restarts automatically.
4. Router has been reset to factory settings.

How do I change the password on my TP-Link TL-MR3020?

Below are the steps about how to find and change the default password.

1. Connect your computer to TL-MR3020’s Ethernet Port with an Ethernet cable.
2. After Login, you will see TP-Link Management Page. Please go to Wireless->Wireless Security.
3. Change this wireless password to your favorite one then Click Save.

How do I connect to a portable router?

1. Using an Ethernet connection

1. Plug the cable into the designated port on the Wi-Fi router.
2. Go to the device settings and turn on the Wi-Fi.
3. Connect to the network set up by the router and you are good to go.

How do I connect my router to a hotel Wi-Fi?

Option 1 – Use a WiFi to WiFi router

1. Locate your hotel room’s ethernet slot.
2. Connect the router to the cable and slot.
3. Switch on your router.
4. Use your laptop to access the router’s page.
5. Use an easily recognizable name as your SSID.
6. Create a password.
7. Leave other options on default.

How do I use my TL MR3020 as a repeater?

How to configure Repeater/Bridge Mode on TL-MR3020 (new logo)?

1. Log in the router.
2. Select Repeater/Bridge Mode and click Next.
3. Click Scan to find the network you want to extend.
4. Either customize your Network Name (SSID) and Password or keep the default ones, and then click Next.
5. Click Save to complete the configuration.

What is the default WIFI password for TP-Link router?

admin
The default IP address is 192.168. 0.1(or http://tplinkwifi.net ), and the default login username and password both are admin (all lower case). 3. Ensure that the IP address of your computer is in the same subnet as the device.