Menu

Navigation

How do I setup a Dlink wireless access point?

Posted on by Arif Clayton

How do I setup a Dlink wireless access point?

How to change a D-Link router to AP mode

  1. Connect a computer to the D-link router and launch a web browser.
  2. Visit the following router configuration page: http://192.168.0.1.
  3. You are prompted to enter a username and password.
  4. Click Setup > Local Network.
  5. Set the DHCP Mode to Off.
  6. Click Apply Changes.

How do I reset my Dlink DIR 524 router?

How to Reset the D-Link DI-524 Wireless Router

  1. Press the reset button for 10 seconds. You can use a small object, such as a paper clip to hold down the button.
  2. Open up your Web browser and enter 192.168. 0.1 in the address bar.
  3. For the login, enter admin as the ID and leave the password blank.

How do I use my D-Link wireless router as a wireless receiver?

Enter http://192.168.1.1 into your browser and login using the default credentials, which is typically a blank username and the password admin. Click Wireless. Change Wireless Mode to Client. In Wireless Network Name (SSID), enter the name of the wireless network you would like the router to connect to.

How do I access my Dlink wireless router settings?

Step 1: Open your web browser and enter the IP address of the router into the address bar (not in google). The default IP is 192.168. 0.1, or using the link: http://dlinkrouter.local. Step 2: You should be taken to a D-Link login page.

How do I connect my WiFi to my wireless router?

Once logged in, follow the steps :

  1. Go to Wireless Page.
  2. Set up your WiFi router name.
  3. Set Router Password.
  4. Save and Apply.
  5. Go to Wireless Repeater Section on Wireless Page.
  6. Enable wireless repeater option, if disabled.
  7. Click Site Survey Button.
  8. Select the primary router name from list of WiFi available.

What are the process to configure the wireless setting?

Then enter the Network key and Confirm Network Key, and then click Next. If you want to setup more than WEP key1, click Advanced….Configure the wireless settings.

(1) Click Start and then Control Panel.
(3) Click Connect to a network.
(4) You can see the SSID of the wireless printer in the list. Select SETUP and click Connect.

How do I access my wireless router settings?

Find Your Router’s IP Address You log into your router’s firmware through a browser. Any browser will do. At the address field, type the IP address of your router. Most routers use an address of 192.168.1.1.