How do I get the code for my Polaris Ranger?
The codes will start to display. You can clear them by disconnecting the battery for 20 seconds, especially for code 25, but the others you’ll probably want to look into a little closer, for instance a short to ground can cause a fire under the right circumstances.
How do you check the engine code on a Polaris general?
If the CHECK ENGINE lamp or the EPS lamp illuminate, retrieve the active error codes from the display.
- Press and hold the MODE button to enter the settings menu.
- Press either toggle button to cycle to the DIAGCODE option.
- More than one diagnostic code may be present.
What does XP mean on a Polaris Ranger?
XP stands for Xtreme Performance, as polaris states it….all 550’s and 850’s are an XP.
How do you reset the code on a Polaris RZR?
Disconnect both battery terminals. Touch both terminals together and hold for 10 seconds. Reconnect to battery. That should do it.
How do I check the miles on my Polaris Ranger?
Use the mode button (3) to toggle through the display and find the engine hour meter. The engine hour meter can be found within the information display area (1 in below diagram) of the rider information center, along with the odometer, trip meter and programmable service hour interval.
What kind of job can a Ranger XP 1000 do?
The performance of a RANGER XP 1000, with added features to dominate in the mud. Built for the biggest Texas ranch jobs with premium refinements and enhanced capability.
What does the code p0102 mean on a MAF sensor?
Mass Airflow (MAF) Circuit Low Voltage Input The code P0102 code is often associated with P0100, P0101, P0103 or P0104 trouble codes as they are closely related. What the P0102 code means P0102 is the general code for a problem with the Mass Airflow (MAF) Sensor having a low voltage output to the Engine Control Unit (ECU).
What’s the RPM on a 12 Ranger crew 800?
I had the same issue mines a 12 Ranger Crew 800, when it gets warm the RPMs would shoot up to about 1400 when its suppose to idle around 1200 1250. I pulled my primary clutch and cleaned it with break part cleaner and a green scruff pad and haven’t had a issue since.
What makes a Polaris Ranger XP 1000 trail boss?
The RANGER XP 1000 Trail Boss includes all the features of the XP 1000 plus capability upgrades including 29″ tires, high clearance arched A-Arms, and self-leveling suspension for more ground clearance. Limited Availability. The performance of a RANGER XP 1000, with added features to dominate in the mud.
What does p0102 mean on a Ford Ranger?
P0102 is a very common trouble code in the Ford Ranger. It means the the Mass Air Flow (MAF) circuit is low, and that it is not performing within its specified operating range.
What to do if you get a p0102 fault code?
Verify the code with a scanner. Reset the fault codes and perform a road test with normal driving. If the P0102 code comes back, then it is important to follow the test procedure. Inspect the electrical connector to the MAF to insure it is attached correctly.
What is mass airflow sensor on Ford Ranger?
Since P0102 has to do with the Mass Airflow Sensor, which is a huge part of the Ranger’s engine combustion process metering, it is going to cause noticeable symptoms. Usually, one or more of these symptoms will occur, but it’s not uncommon to have no symptoms other than the check engine light.