How do I fix the spin cycle on my Samsung washer?

How do I fix the spin cycle on my Samsung washer?

Samsung Washing Machine Not Spinning? 6 Easy Fixes to Try

  1. Distribute the washing evenly around the drum.
  2. Fix an overloaded or underloaded machine.
  3. Switch the washing machine off and on again and start a new program.
  4. Clean the drain pump filter.
  5. Clear the drain hose.
  6. Fix the motor.

Why does my Samsung washer take so long?

A washer that continuously takes too long to wash may have a malfunctioning load sense system, or greater problems with its control panel. There may also be issues with your water inlet valve, which pulls water into the appliance for each cycle.

Is Samsung a reliable washer?

Samsung front-load washers rank highest in customer satisfaction, according to J.D. Power’s laundry appliance satisfaction study, and Samsung was named a most reliable brand by Yale Appliances and Puls repair technicians, as well. It’s an easy-to-use, energy- and water-efficient washing machine that just works.

What does code 8C mean on a Samsung washer?

In the Samsung washer, the 8C error code is displayed when the accelerometer is “silent” or gives incorrect/ weak signals to the control module. Switch on the washing machine.

Can I reset my Samsung washer?

To reset your Samsung washing machine you need to simply disconnect the washing machine from power for 5 to 10 minutes. Once the 5 to 10 minutes has passed, connect power to your Samsung washer and run a test wash load to see if the error code has cleared.

Why does my Samsung washing machine keep stopping?

Common solutions for: Samsung Washer stops mid cycle If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.

Why does my Samsung washer not finish spin cycle?

The failure to complete the spin cycle can be caused by a slow drain and that code will appear. To correct the slow drain, open the bottom panel of the washer housing. You will see a plug on the lower right. Have some towels ready to catch a gush of water and remove the plug.