How do I disable driver side airbag?
How to Disable Airbag System? Find out here!
- Purge the Power. The first step involved in the process of how to disable airbag system in your car is to cut off the power.
- Take Out the Fuse.
- Take Away the Dashboard Cover.
- Immobilize the Passenger Airbag.
- Remove the Steering Wheel’s Lower Panel.
- Finally, Disable the Airbag.
Can you disable the airbag?
But the passenger airbag can be deactivated if the car is equipped with a Passenger Airbag Cut Off Switch (PACOS). In most cases, to disable the airbag you need to have the ignition switched off to avoid any possible malfunctions. The PACOS is usually located in the passenger side of the dash board.
How do I turn off airbag warning?
Turning off the airbag light yourself can save you a trip to your car dealer.
- Turn on the ignition switch with your car key.
- Wait for the airbag warning light to turn off.
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
What happens if you unplug an airbag?
If you unplug them and start the car, you will trigger an airbag fault that turns the SRS light on. Except for this minor detail, there should be no problem with doing this.
How do you remove airbag from steering wheel?
For some applications the bolts will be retained in the wheel and will not come out which is normal. Once one side has been removed or released turn the steering wheel in the opposite direction 180°. Then locate and loosen or remove the opposing mounting bolt or retainer clip. Gently grasp the assembly while pulling it away from the steering wheel.
What’s the best way to replace driver side air bags?
Let the car sit for about 15 minutes to fully drain the capacitors. Step 2: Locate the screw holes on the back of the steering wheel. You may have to remove some of the plastic panels on the steering column to access all of the screws.
How do you reinstall an airbag in a car?
Once repairs are completed such as removing the steering wheel to replace the turn signal switch, cruise control or ignition switch simply reinstall the airbag by reversing these steps. Most electrical connectors produce an audible click to confirm their proper installation.
How do you take out seats with airbags?
How to Remove Seats With Airbags. Allow the vehicle to sit for 20 minutes before you start to take out the seats. Unbolt the seat from the chassis of the car, using a 3/8-inch ratchet and socket. Once the bolts are out, tilt the seat forward and unplug the harness for the seat belt and the airbag, using your hands.