Do you have to remove rear axle shafts?
This is what I used to replace my rear dust shields. This procedure can be used for that as well as axle replacement, parking brake replacement, or anything in which you have to remove the axle. I am at work currently, so I can not upload my color pictures.
How to change General Motors RWD rear axle bearings?
How to Change General Motors RWD Rear Axle Bearings 1. Park on a flat and level surface and leave the parking brake off. Block both the front and rear of one (or both)… 2. Shift the transmission into neutral. 3. Slide the drain pan under the differential. Remove the bolts securing the cover to …
Where is the rear axle shaft located on a car?
A rear axle shaft is found on vehicles with rear wheel drive or all wheel drive. The rear axle transfers power from the rear differential to the drive wheels. The axle uses two joints to provide flexibility in the joint. Over time, these joints eventually fail and begin to grind.
What to do when rear axle bearings fall out?
Look inside the carrier in the opening left by the pin removed above at the axle ends and remove the clips. If a clip is missing, check the bottom of the differential housing. It probably fell out when you pushed the axles inward. If you’re only replacing one bearing, only push inward on that axle.
How to Change General Motors RWD Rear Axle Bearings 1. Park on a flat and level surface and leave the parking brake off. Block both the front and rear of one (or both)… 2. Shift the transmission into neutral. 3. Slide the drain pan under the differential. Remove the bolts securing the cover to
What happens when rear axle bearings go bad?
A rear axle bearing that has gone bad or is going bad announces itself by squeaking occasionally and moves on to clunking and shaking because the bearing has completely failed and fallen apart. Whether you’ve got a Chevy/GM 10-bolt rear-end or a 12-bolt, changing the rear axle bearings is a relatively quick and easy repair to complete at home.
How do you remove a wheel from a CV axle?
Tape the steering knuckle joint with a hammer (hitting the knuckle where the rod goes through and not the threaded portion of the tie rod) to help remove it. Unbolt the hub from the strut tower. Two more 17mm bolts will connect the wheel hub to the strut tower.
What’s the best way to change an axle?
By this time, you can put the wheel back on the vehicle (again, the same as you would when changing a tire). After the wheel is on, you can lower the car off the jack and jack stands. Tighten the axle nut. Finally, you can retighten the axle nut once the vehicle is back on the ground.