Can you replace the starter in a 2011 Hyundai Sonata?
The starter in a 2011 Hyundai Sonata is a challenge to replace owing to it’s position high on the engine and obstructions blocking removal. This post will provide some helpful tips in removing and installing this starter.
What are the repair procedures for a Hyundai Sonata?
Repair procedures Hyundai Sonata YF 2011-2014 Service Manual / Engine Electrical System / Starting System / Starter. Repair procedures 1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). 3. Remove the air duct (B). 4. Remove the air cleaner assembly.
Can a bad battery kill a Hyundai Sonata starter?
If it has less than 12.5 volts, the battery or charging system is suspect. It is possible for a battery to show 12.5 or better on voltage and a bad cell, which would kill the amperage output. Amperage output is needed to activate the starter. Put the voltmeter’s negative lead on the negative battery post and the positive lead on the positive post.
What should the voltmeter be on a Hyundai Sonata?
Set the voltmeter to 20 volts dc. Check the battery—it should have 12.5 volts or more. If it has less than 12.5 volts, the battery or charging system is suspect. It is possible for a battery to show 12.5 or better on voltage and a bad cell, which would kill the amperage output.
How do you remove starter from Hyundai Sonata?
Disconnect the starter cable (A) from the B terminal on the solenoid, then disconnect the connector (B) from the S terminal. 8. Remove the 2 bolts (C) holding the starter, then remove the starter. 9. Installation is the reverse of removal. 1. Disconnect the M-terminal (A) on the magnet switch assembly (B). 2.
Repair procedures Hyundai Sonata YF 2011-2014 Service Manual / Engine Electrical System / Starting System / Starter. Repair procedures 1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). 3. Remove the air duct (B). 4. Remove the air cleaner assembly.
What should the amperage output be on a Hyundai Sonata starter?
Check the battery—it should have 12.5 volts or more. If it has less than 12.5 volts, the battery or charging system is suspect. It is possible for a battery to show 12.5 or better on voltage and a bad cell, which would kill the amperage output. Amperage output is needed to activate the starter.
What to do if there is no power in the starter?
If there was no power at the switch, then go to the ignition key, which is the next step in line. Remove the bottom cover on the steering column and check the yellow wire for power when the key is in start. If there is no power, replace the ignition switch electrical side.