Can a camshaft sensor cause a car not to start?
If you ignore the symptoms listed here and your camshaft position sensor fails, your vehicle will not start. As a camshaft position sensor weakens, so does the data it transmits to the ECM. Eventually the data signal becomes so weak the ECM switches off fuel and spark delivery, and your engine will not start.
What trouble code would the PCM set for a bad sensor?
The OBD-II diagnostic trouble code P0340 indicates a “Camshaft Position Sensor “A” Circuit Malfunction.” It covers the entire circuit attached to the aforementioned sensor, such as the electric wiring and the powertrain control module (PCM). Thus, replacing the sensor will not always resolve the issue.
How do you fix a p0341 code?
Inspect the wiring at the camshaft sensor for melting or marks of corrosion. Inspect the camshaft sensor for damage. Inspect the camshaft reluctor wheel for missing or damaged teeth. You may need to remove the timing chain cover to inspect the reluctor wheel if it is not visible by removing the camshaft sensor.
How to diagnose p0341 on a 2009 VW?
P0341 Code: Camshaft Position Sensor ”A” Circuit Range/Performance (Bank 1 or Single Sensor) – In The Garage with CarParts.com How to diagnose P0341 on a 2009 VW CC
What are the symptoms of the p0341 code?
What are the symptoms of the P0341 code? 1 The Check Engine Light will be illuminated and the code is set in ECM memory. 2 The engine could stall or not start when failure is present. 3 The engine may have a misfire and may buck or jerk while driving for an intermittent connection. 4 The engine may not start or have low power if it does start.
What is the OBD code for a VW?
OBD2 Code P0341 Volkswagen definition: This P0341 Volkswagen code basically means that the powertrain control module (PCM) detected a problem with the camshaft signal. The camshaft position sensor (CPS) sends a specific signal to the PCM for Top Dead Center on the compression stroke as well as signals indicating the position of the cam sensor.