Why is my Saab check engine light on?
This is not a normal “wear and tear” issue, but an issue dealing with parts that were doomed from the beginning. The contact owns a 2007 SAAB 9-3. The vehicle stated that while driving approximately 55 mph, the check engine warning light illuminated. The failure occurred on several occasions.
Are there any problems with the Saab 9-3?
SAAB 9-3 owners have reported 26 problems related to check engine light on (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of SAAB 9-3 based on all problems reported for the 9-3.
What causes MAF sensor to go bad in Saab?
MAF sensor may function fine when the engine is cold then start to malfunction once the engine warms up. A coolant temperature sensor can go bad with time, causing the engine to run rich and preventing it from going into the ‘closed-loop’ mode.
Where is the fault code stored on a Saab?
Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes. When your Saab check engine light comes on, you may notice:
Why does my Saab check engine light keep coming on?
When your Saab check engine light stays on, it means that the On-Board Diagnostic (OBD) computer has detected a malfunction. The cause could be an engine problem, a fuel system leak, or even an indication of a transmission issue. Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes.
Since a fault code will be stored in your Saab’s OBD computer, you can use an OBD-II scanner to read those codes. When your Saab check engine light comes on, you may notice:
MAF sensor may function fine when the engine is cold then start to malfunction once the engine warms up. A coolant temperature sensor can go bad with time, causing the engine to run rich and preventing it from going into the ‘closed-loop’ mode.
What should I expect when I visit my Saab mechanic?
If you also notice on your dash, in addition to the activated check engine light, that you have low oil pressure or your Saab is overheating, you should safely pull off the road as soon as you can and shut off the engine. What Should I Expect When I Visit my Saab Mechanic for Diagnosis?
How much does it cost to rebuild a Saab 9 3?
Had a compression test following several check engine lights and multiple readings diagnose a p0300 engine code . Cold and warm compression test showed cylinder 2 compression well out of specification. Documents available upon request. Quoted $4000 for engine rebuild. See all problems of the 2008 SAAB 9-3 .
Why does my car sputter when I drive?
Driving should be smooth. But, if you are driving and your car’s engine starts sputtering the first cause of concern would be low fuel. However, if your fuel gauge is full it could be a symptom of further engine problems. A blocked fuel injector can prevent fuel from reaching the combustion chambers.
What does the Check Engine light mean on a Saab?
When your Saab check engine light comes on, you may notice: Engine shaking or juddering. Check engine light flashing. In some cases, you may not notice any performance issues at all, as would be the case if you forget to tighten the gas cap. With a ‘check engine’ light on, the first thing you need to find out is what caused it.
SAAB 9-3 owners have reported 26 problems related to check engine light on (under the engine and engine cooling category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of SAAB 9-3 based on all problems reported for the 9-3.