Why is my Check Engine light on after the fuel tank overflowe?
Went to Costco’s filled up tank like I usually do on Sunday pump did not shut off show’s over run over on the ground my wife was driving the car it died a couple of times then it was okay and now the engine light came on did it hurt anything My car has 24500 miles. My car has an automatic transmission.
When does the Check Engine light come on?
How To Reset Check Engine Light: Follow These 4 Easy Ways! The check engine light comes on when your car’s computer detects an issue within the powertrain. It can indicate a major or minor complication, but ignoring it definitely makes the problem worse, leading to costly damage and repair.
Why does my Car start at 4K rpm?
So I revved it up to about 4-5k RPM’s for about 5 seconds and that seems to smoothened things out. It started just fine this morning, not rough or anything. Drove well as usual. I’m leaning towards something fuel related. So was it bad gas (perhaps too much deposits at the bottom of the tank – fuel filter changed maybe 5k miles ago)? Fuel pump?
Why does my Car start right up after gas station?
Loosen the gas cap and retighten it, try starting the car again. If it has a problem then it’s most likely a bad fuel pump. If it starts right up then it was probably water in the gas, although I doubt NJ has been that cold yet to create that condition. BTW… do this test at home or better yet in your mechanic’s lot.
How To Reset Check Engine Light: Follow These 4 Easy Ways! The check engine light comes on when your car’s computer detects an issue within the powertrain. It can indicate a major or minor complication, but ignoring it definitely makes the problem worse, leading to costly damage and repair.
So I revved it up to about 4-5k RPM’s for about 5 seconds and that seems to smoothened things out. It started just fine this morning, not rough or anything. Drove well as usual. I’m leaning towards something fuel related. So was it bad gas (perhaps too much deposits at the bottom of the tank – fuel filter changed maybe 5k miles ago)? Fuel pump?
Loosen the gas cap and retighten it, try starting the car again. If it has a problem then it’s most likely a bad fuel pump. If it starts right up then it was probably water in the gas, although I doubt NJ has been that cold yet to create that condition. BTW… do this test at home or better yet in your mechanic’s lot.
How to reset check engine light with scan tool?
Use A Scan Tool 1 Connect the scan tool to the OBD – II Connecting the scan tool to the OBD- II ( On- board diagnostic connector) under your steering column. 2 View error codes by pressing the “READ” button Pressing the “READ” button on the scan tool to see the error codes of the engine. 3 Remove the error code
Went to Costco’s filled up tank like I usually do on Sunday pump did not shut off show’s over run over on the ground my wife was driving the car it died a couple of times then it was okay and now the engine light came on did it hurt anything My car has 24500 miles. My car has an automatic transmission.
What to do if your check engine light is still on?
If the check engine light is still on after three days, your problem may not have been fixed or you may need to try some of the methods below to reset it. 2. Turn the Car on and off Three Times Some vehicles will automatically reset the trouble codes that caused the initial error after the vehicle is turned on and off three times in succession.
What does it mean when your Volvo check engine light comes on?
Do not drive your Volvo under a load when your Volvo check engine light is flashing. If your Volvo check engine light comes on for a few days then goes off a few days later, it means that the on-board diagnostic system is detecting a problem intermittently.
Why does my check engine light turn orange?
When it runs into an issue that the ECU cannot correct, the check engine light (CEL) starts glowing. The light is typically yellow or orange, and features an image of engine with text telling the driver to check or service the engine or powertrain. The engine computer stores a diagnostic code when the light begins glowing.