Why is my car guzzling coolant?
Coolant loss may indicate a poorly maintained cooling system, a system fault, or even a change in driving patterns. For example, a coolant leak could have any of these causes: A leak that only occurs under certain operating conditions. An undiagnosed cracked engine block or cylinder head, or a blown gasket.
Why am I out of coolant?
Disappearing engine coolant could be the result of a slightly cracked hose, a tiny hole in your radiator, or a water pump issue. It’s also possible for a coolant leak to develop inside your vehicle or to simply vaporize into mist via your defroster.
Are there any problems with the Kawasaki Vulcan?
Most of the problems on the Kawasaki Vulcan models that have to do with the regulator/rectifier will mask themselves as battery issues. This particular problem with the stator is apparent on the Vulcan 800 Classic, Vulcan 750, Vulcan 900 models. Stators are generally in charge of the charging system on a bike.
What makes a Vulcan 900 make a squealing noise?
Problems with the drive pulley will usually show themselves as noises coming from the belt. It sounds like the belt is rubbing up against something and producing a squealing noise. Owners of the Vulcan 900 who came across this problem stated that it showed up after the bike had fallen or had gotten into an accident.
Why is my speedometer not working on my Vulcan 800?
On the Vulcan 800, the speedometer cable housing can be a bit tricky to get to. So those who fixed the problem were able to use a pair of long-nosed pliers to get the housing closed. A visit to the mechanic might be next for those who aren’t mechanically inclined.
Can a defective radiator cap cause engine to overheat?
A defective radiator cap will cause engine overheating in a number of ways. Three of the ways a radiator cap can cause overheating are, 1) Not holding in pressure and allowing the coolant to vent out or escape the cooling system. 2) No providing the proper pressure and not raising the boiling point.
Most of the problems on the Kawasaki Vulcan models that have to do with the regulator/rectifier will mask themselves as battery issues. This particular problem with the stator is apparent on the Vulcan 800 Classic, Vulcan 750, Vulcan 900 models. Stators are generally in charge of the charging system on a bike.
Problems with the drive pulley will usually show themselves as noises coming from the belt. It sounds like the belt is rubbing up against something and producing a squealing noise. Owners of the Vulcan 900 who came across this problem stated that it showed up after the bike had fallen or had gotten into an accident.
On the Vulcan 800, the speedometer cable housing can be a bit tricky to get to. So those who fixed the problem were able to use a pair of long-nosed pliers to get the housing closed. A visit to the mechanic might be next for those who aren’t mechanically inclined.
When to change drive pulley on Kawasaki Vulcan?
Drive pulley problems usually occur between 2,000 miles and 9,000 miles on the Vulcan 900. Swapping out the belt for a new one can work, but the tension must be just right when installing the new drive belt. So it is recommended to have a mechanic or dealership deal with the installation.