Why is it having trouble moving in reverse?

Why is it having trouble moving in reverse?

So when forward and reverse are selected at the same time the transmission binds and the car ends up going nowhere fast. The more revs you give it the worse it gets. They replaced the main shaft and now the problem is gone. Read more at http://www.honda-tech.com/showthread.php…

Why does my car go forward and reverse at the same time?

The crack would open up when the trans oil was hot (and thinner), so when reverse was selected, it would also engage the forward drive gear at the same time (^ due to pressure bleed). So when forward and reverse are selected at the same time the transmission binds and the car ends up going nowhere fast. The more revs you give it the worse it gets.

Is it possible to fix a transmission crack?

Yes we did resolve the problem in the end. The guys that originally rebuilt the transmission ended up pulling it apart again. They found that there was a hairline crack on the main shaft where it joined with the clutch pack that contains the reverse gear.

Why is my p4-p1 having trouble moving in reverse?

P4 – P1 100% transmission fluid is good. The other day I accelerated putting my foot flat on the petrol. After that me neutral is off center. When I shift it up to neutral I have to shift it little bit past neutral like 3-4mm then it takes and when I shift to reverse after about 4-5 secs it kicks hard into reverse.

What causes no reverse on a 4R44E transmission?

Loss of certain gears can occur due to issues in at least two other circuits. Loss of solenoid oil due to end plug leakage can cause no Reverse, and loss or 3rd or 4th and can be repaired with 37947-13K.

What should I do if my truck won’t reverse?

The Transmission Range Sensor might be damaged. If it is, your truck should give you a check engine light. Replace it if necessary. Figure 1. This is the gear selector lever on the Torqueshift transmission for Super Duties. A similar looking unit will be in the same place on other transmission types .

What causes a car to have trouble moving in reverse?

Two things can be wrong, either your transmission has bad transmission fluid in it or has none, and that will tear up your gears and the second is rebuilding your transmission. This is cheaper than a whole new one and you only repair the injured parts.

Yes we did resolve the problem in the end. The guys that originally rebuilt the transmission ended up pulling it apart again. They found that there was a hairline crack on the main shaft where it joined with the clutch pack that contains the reverse gear.

Why does my car not go into reverse?

If your car wont go into reverse – it’s likely the shift cable needing adjustment.

So when forward and reverse are selected at the same time the transmission binds and the car ends up going nowhere fast. The more revs you give it the worse it gets. They replaced the main shaft and now the problem is gone. Read more at http://www.honda-tech.com/showthread.php…

P4 – P1 100% transmission fluid is good. The other day I accelerated putting my foot flat on the petrol. After that me neutral is off center. When I shift it up to neutral I have to shift it little bit past neutral like 3-4mm then it takes and when I shift to reverse after about 4-5 secs it kicks hard into reverse.

How did the no reverse complaint fit into this scenario?

Also, as stated, there was no reverse gear engagement. Since solenoid ‘E’ is responsible for converter lockup, the code fit that symptom perfectly, and since this code was out there, the fail-safe 2nd gear starts also made sense. How did the no reverse complaint fit into this scenario?

What happens when I put the car in reverse?

Put the car in reverse holding the brake the car stalls, if I go into neutral or drive it works fine. If I put the car in reverse not holding the brake it shifts rough but doesn’t stall. I have not driven the car at speeds higher than 35mph, so not sure of the other gears.

Why does my car Rev when I Shift Into Gear?

Another possibility is that you have brakes that are frozen in the “on” position, thus essentially locking the car in place. When you shift into gear and you hear the engine rev, does it feel like the car is fighting the brakes, or does it feel like no power is going to the drive wheels? IT doesn’t feel like its fighting the brakes.

What makes a car shift gears in reverse?

Every automatic transmission has a valve body. This is large, maze-like component that directs the flow of hydraulic fluid to the valves. This is what allows a car to smoothly shift gears whenever the situation calls for it.

What causes a car to not go in reverse?

This is what allows a car to smoothly shift gears whenever the situation calls for it. In case of a bad transmission valve body, you may experience delayed shifting into reverse or simply nothing happening after shifting in reverse and stepping on the gas.

Every automatic transmission has a valve body. This is large, maze-like component that directs the flow of hydraulic fluid to the valves. This is what allows a car to smoothly shift gears whenever the situation calls for it.

Is it possible to shift a wheel boat into reverse?

It would have forward just fine but it would not shift into reverse. Assuming it’s a wheel boat does the throttle handle go into reverse but reverse doesnt work or does it not even go back to where reverse would be. On the kicker when you went to shift it into reverse the shift lever would not even go backwards.

If your car wont go into reverse – it’s likely the shift cable needing adjustment.

The crack would open up when the trans oil was hot (and thinner), so when reverse was selected, it would also engage the forward drive gear at the same time (^ due to pressure bleed). So when forward and reverse are selected at the same time the transmission binds and the car ends up going nowhere fast. The more revs you give it the worse it gets.

Why is my 2002 accord having trouble moving in reverse?

My 2002 Accord EX-V6 does the same thing. BUT– I have found a fix. If I move it to Drive for a moment, then back to Reverse, it goes OK. It has been doing this for a few months now (147K miles). I had my mechanic check the fluid and replace it.


Is there a problem with my reverse gear?

If you have noticed that your reverse gear has become sluggish, unresponsive or delayed, there is a chance your car may need transmission work. Transmission problems are not an uncommon vehicular problem, and it is important to address them promptly to keep them from becoming a serious hazard on the road.

Why is there lag when shifting into reverse with an..?

Constant shifting can put strain on your vehicle, which may manifest in the form of a delay or lag of a few seconds when putting the vehicle in reverse. If you have noticed that your reverse gear has become sluggish, unresponsive or delayed, there is a chance your car may need transmission work.

Why does my transmission take so long to reverse?

Good fluid will not fix a bad transmission… the VW’s are pretty good at detecting bad solenoids. They give you a code almost instantly… Chance are the valve body is worn allowing the fluid to slip past and cause pressure issues. Delayed drive and reverse are symptoms of this.