Why does my Mercedes not Rev at 3000rpm?
Another cause could be a leaking pilot bush, this is the large electric plug on the side of the ‘box and when leaking it allows atf fluid from the ‘box to ‘track’ inside its wiring loom and enter the transmission ecu (located inside the cabin) causing a few electrical gremlins. .
What to do when your Mercedes goes into limp mode?
You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level.
Why does my Mercedes powerloss not Rev properly?
PROBLEM still present . Then oddly when it did start it would not accelerate properly almost as if in limp mode?. they then said no 4 injector had to be replaced and IT WORKED started everytime since then for 2 months . However, now at times it will not accelerate properly and in neutral wont rev above 3000rpm .
Can a car go over 2500 rpm in first gear?
My car will not exceed 2500 RPM in any gear. In first (or any other gear) gear I can drive up to 2500 RPM and then must shift into 2nd (or the next gear) if I want to go faster, if RPM goes above 2500 the car stops accelerating and the RPM drops to 2000 at which time the car starts to accelerate again.
Why does Mercedes powerloss not Rev above 3000rpm?
Then oddly when it did start it would not accelerate properly almost as if in limp mode?. they then said no 4 injector had to be replaced and IT WORKED started everytime since then for 2 months . However, now at times it will not accelerate properly and in neutral wont rev above 3000rpm .
What kind of car will not Rev past 3000 rpm?
I have a year 2000 E220CDI and the engine will not rev higher than 3000 rpm. It starts ok and runs ok for a while then the problem appears, quite worrying when your trying to overtake or coming out of a junction and suddenly the car will not accelerate!!
You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level.
What causes a Mercedes-Benz transmission to fail?
We see these transmission fail in rare cases when water enters the transmission via the oil cooling lines or the radiator on cars equipped with Valeo radiators. The top part of the radiator on your Mercedes-Benz contains the chamber for the engine coolant/antifreeze while the bottom part contains the chamber for the transmission oil cooling.