Which is Detroit engine controller supports DDEC reports?
DDEC Reports DDEC Reports is a fleet management application that includes support for Detroit engine controllers: DDEC 3-5 ECU, VCU, CPC2, CPC02T, CPC04T, CPC302T, and CPC501T. DDEC Reports provides useful data reports including:
What does the red indicator mean on a DDEC system?
The DDEC system is easy to operate, and diagnostic functions are displayed to the driver. Typically, there are two indicator lights, one in yellow and one in red. The red indicator represents a significant-engine fault, and in most cases, the engine shuts down to protect the engine from damage.
Why are there no DDEC reports on my truck?
There are fault codes for RTC (real time clock) battery high and low conditions and these would most likely be shown in DDDL – not DDEC Reports. The message may indicate that data pages are disabled on the vehilce. If the CPC fleet management data page parameter is disabled, the trip data will not be collected.
How many horsepower does a DDEC 2 engine have?
The DDEC II Engine was available in ratings between 365 hp (272 kW) and 500 hp (373 kW) of torque. The engine proved extremely popular with fleet operators, and built a strong reputation for reliability and longevity.
How to troubleshoot code 25 on Detroit Diesel?
If any code (s) other than code 25 is logged, refer to the Detroit Diesel Single ECM Troubleshooting Manual (6SE497). Always start and operate an engine in a well ventilated area. If operating an engine in an enclosed area, vent the exhaust to the outside.
Do you need administrator access to install DDEC reports?
When installing DDEC Reports, full administrator access is required. Attempting to install the application as an administrator under a non-administrator account will likely result in installation errors. The internal battery is only used for the clock, NOT DATA.
Where is the height Gage located on a DDEC?
A height gage locating hole is provided in the injector body on the machined surface contacted by the injector clamp near the solenoid. See Figure “Using Timing Gage on DDEC II, DDEC III, and DDEC IV” . Figure 2. Using Timing Gage on DDEC II, DDEC III, and DDEC IV
Where is the timing Gage located on a DDEC engine?
On engines equipped with a Jake Brake®, move the handle on the injector height gage to the alternate position, 90 degrees to the shank. A height gage locating hole is provided in the injector body on the machined surface contacted by the injector clamp near the solenoid. See Figure “Using Timing Gage on DDEC II, DDEC III, and DDEC IV” . Figure 2.