Which features are not supported in transparent mode?
Features Not Supported by Transparent Mode –
- DHCP relay – The transparent firewall can act as a DHCP server, but it does not support the DHCP relay commands.
- Dynamic routing protocols will not be allowed, however, we can add static routes for traffic originating on the ASA.
- Multicast IP routing.
- QoS.
What are two features of transparent firewall mode?
It supports multiple interfaces with each interface on a different subnet and can perform network address translation (NAT) between connected networks. In transparent mode, the firewall is an L2 device and not an L3 or routed hop.
What is a characteristic of a bridge group in Cisco ASA firewall running in transparent mode?
What is a characteristic of a bridge group in a Cisco ASA Firewall running in transparent mode? A. It has an IP address on its BVI interface and is used for management traffic.
What is transparent mode Cisco?
VTP Transport mode does not synchronize VLAN configuration information with other switches. This mode is used when you want to make the switch independent from current vlan structure. This mode has lowest impact when adding new switch to your switching topology.
What are three characteristics of ASA transparent mode?
This mode does not support VPNs, QoS, or DHCP Relay. It is the traditional firewall deployment mode. In this mode the ASA is invisible to an attacker. NAT can be implemented between connected networks….What are three characteristics of ASA transparent mode? (Choose three.)
| Network Security 1.0 | |
|---|---|
| Final Exam & Lab PT Skills | |
| Final Exam Answers | Online Test |
Which of the below is a failover mode supported by ASA?
There are two different failover modes that are supported on the ASA platform: active/passive and active/active.
Why do we need transparent firewall?
Using a firewall in transparent mode also allows non-IP traffic through, which is not possible in routing mode. A transparent firewall enables any traffic—even non-IP traffic like AppleTalk, bridge protocol data units, and IP exchange—to pass through the network.
How do you use transparent mode?
Press and hold the force sensor on the stem of an AirPod until you hear a chime. When you’re wearing both AirPods, press and hold the force sensor on either AirPod to switch between Active Noise Cancellation and Transparency mode.
What is transparent mode?
Transparent mode is also known as bridge mode or transparent bridging mode. Transparent mode is used when the IT administrator does not wish to change the existing network layout. Normally, the existing network has already set up routers and switches. The firewall will be used as a security device.
Is ASA in transparent?
An ASA Firewall is capable of operating at Layer 2 when running in transparent mode. This allows it to be installed into the network with minimal distruption becaue no IP addressing changes are needed on the network.
What is ASA transparent mode?
Overview. An ASA Firewall is capable of operating at Layer 2 when running in transparent mode. This allows it to be installed into the network with minimal distruption becaue no IP addressing changes are needed on the network.
What is one limitation of a stateful firewall?
What is one limitation of a stateful firewall? Limitations of stateful firewalls include the following: Stateful firewalls cannot prevent application layer attacks. Protocols such as UDP and ICMP are not stateful and do not generate information needed for a state table.