Where is the OBD on a slingshot?
The OBD port on these is hidden up on the right side of the steering column and is behind the plastic trim piece.
What to look for in a BMW diagnostic connector?
What to look for? A round 10-pin connector , usually covered with a cap. In later (2016+) EURO4 compliant bikes, the connector will be the rectangular 16 pin OBD2 compatible form factor. (Note: NOT the one in the red Square!!)
Where is the DVM on a BMW K?
Locate the diagnostic connector under your seat. Temporarily remove blue dummy plug if yours still has it. Connect the positive lead of an analogue tester or DVM to the 2nd (middle) terminal hole. *You can use only fast response DVM to read.
What to look for in a BMW K1100LT?
❍Check Valve Clearance on a K1100LT – Mike Nolan ❍Cold Running Problems, Things to look for – Rob Lentini ❍Coolant Change Trick – Fred Scott (September 2000) ❍Cooling Fan Diagnostics – Jeff Dunkle ❍Diagnose Gas Mileage Problems – Don Eilenberger (June 2000)
What was the ABS code on my BMW K100?
In 2005 I purchased a 1990 K100 RS that had a fault with the ABS system which showed up as an error code 7 following a bit of research I tried to reset it but that did not work.
What to look for? A round 10-pin connector , usually covered with a cap. In later (2016+) EURO4 compliant bikes, the connector will be the rectangular 16 pin OBD2 compatible form factor. (Note: NOT the one in the red Square!!)
Is the gs-911 diagnostic tool for late 1990-2016 BMW motorcycles?
This version is designed to be used with late 90’s-2016 model BMW Motorcycles that have a 10-Pin diagnositic connector. It is also compatible with 2017-on models when used in conjunction with the Male OBD-II Adaptor Cable. *SEE APPLICATIONS TAB FOR MODELS SUPPORTED. INTERNATIONAL CUSTOMERS, please see *message* below.
How to fix BMW K Series ABs brain?
This site will help to fix your problem with your BMW K Series ABS error . I can repair your faulty ABS brain (ECU). 3.How to reset the ABS brain. 7. 25 pin ABS connector pin assignment. 7A. How to disconnect the 25pin ABS connector. 8.Error code and defective components. 9.Correct diagnostic LED connection or you will get error 7.
In 2005 I purchased a 1990 K100 RS that had a fault with the ABS system which showed up as an error code 7 following a bit of research I tried to reset it but that did not work.