Where is the governor on a 50cc scooter?
Your scooter’s rev limiter prevents its engine from transferring all of its energy to the drive belt. It is located in your scooter’s drive belt or variator system on the left side of the scooter.
What happens when you remove the governor from a scooter?
Removing this washer from the variator ostensibly removes the scooter’s governor. Removing your scooter’s governor washer from the variator system removes the operating speed regulations for your scooter’s engine, allowing your scooter to travel faster. Remove the kick stand.
How to remove the governor for a 50cc Honda Metro scooter?
Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.
How do you remove Governor from Honda variator?
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
How do you remove Kickstart from Honda Metro scooter?
Pulling it will allow you to remove the kickstart from the side of your scooter. Remove the intake case from its position above the variator case. The intake case is held in place by three bolts that can be unscrewed with a standard socket wrench. Removing the case will give you more space to work with the variator system.
How do you remove the governor on a scooter?
Take the faceplate off of the front pulley wheel to access the governor washer. Pull the governor washer off of the pulley rod by hand.
Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.
Pulling it will allow you to remove the kickstart from the side of your scooter. Remove the intake case from its position above the variator case. The intake case is held in place by three bolts that can be unscrewed with a standard socket wrench. Removing the case will give you more space to work with the variator system.
How do you remove the kick stand from a scooter?
Remove the kick stand. Pull the pin attaching the scooter to the variator box up and out and then pull the kick stand off of the box. Set the kick stand aside. Unscrew and remove the two bolts holding the plastic cover of the intake box if your scooter has one.