Where is the fuse box on an Acura MDX?
The primary under-hood fuse box is located in the back of the engine compartment on the passenger’s side. The secondary fuse box is in the engine compartment next to the battery. The interior fuse boxes are located underneath the dashboard on each side. To open the fuse box on the passenger’s side, pull the right edge of the cover. Amps. Amps.
What are the fuses on a Ford Escape?
F62 5A Auto-dimming interior mirror. Rain sensor module F65 10A Lifigate latch. Liftgate/decklid release relay F66 20A Driver door unlock relay. Door latch, left from F67 7.5A Front Control/Display Interface Module (FCDIM).
Why are the tail lights not working on my Mercedes?
In case the tail lights were working after the SAM was replaced but stopped after the lights were tested, this would be an indication of short circuiting. The driver for tail lights inside the module could have blown. The wiring between the Mercedes tail light and module can be checked.
Why is my seat belt light not working?
This may be a sign of a failing idle air control valve. The idle air control valve is located on or near your intake manifold that monitors the air intake as it is mixed with fuel prior to being injected… How do I inspect the seat belts?
The primary under-hood fuse box is located in the back of the engine compartment on the passenger’s side. The secondary fuse box is in the engine compartment next to the battery. The interior fuse boxes are located underneath the dashboard on each side. To open the fuse box on the passenger’s side, pull the right edge of the cover. Amps. Amps.
What to do if rear brake light is not working?
Check for power and ground at the turn and brake light sockets. I suspect in your case you will have a good ground but you won’t have any power. If you discover there is a bad ground, this will be the simplest repair.
This may be a sign of a failing idle air control valve. The idle air control valve is located on or near your intake manifold that monitors the air intake as it is mixed with fuel prior to being injected… How do I inspect the seat belts?