Where is the dipstick on a 660 grizzly?

It’s a sight glass. Look low, down below the spot where you can add oil. You’ll see a glass porthole around the size of a quarter. It should be an inch or so above the edge of the left floorboard.

How do you change oil on a 600 Grizzly?

Allow the oil to drain into the pan for about 10 minutes. Remove the three bolts that secure the engine oil filter cover — from the side you removed the engine cover from. Pull the oil filter straight off. Remove the oil filter o-ring (found on the underside of the oil filter cover) and the drain plug gasket. They cannot be re-used.

Where is the oil dipstick on a Suzuki bike?

Stand the bike as upright as possible, using a portable motorcycle lift if possible. Locate the dipstick on the motor and unscrew it. The dipstick is located on the left side of the bike when you are sitting on it, tucked just under the cylinder. Wipe the oil off the dipstick with a rag.

Where is the oil drain plug on a grizzly?

Place your oil drain pan underneath the Grizzly. Twist off the oil filler cap — it’s also the dipstick — and set it aside in a safe place. Remove the oil drain plug with a socket wrench; it’s located on the underside of the Grizzly.

What are the specs of a Yamaha Grizzly 600?

Yamaha Grizzly 600 Specs 1999-2000 YFM 600 4×4 . Front Tires 25x8x12. Rear Tires 25x10x12. Battery YTX20L-BS. Spark Plug DP8-EA900-00-00 (DP8EA-9) Oil Filter 4X7-13440-90-00. Air Filter 1UY-14451-00-00

What kind of oil do you put in a Grizzly 600?

Add the replacement oil through the oil filler port, using a funnel. The Grizzly 600’s capacity is 2.1-quarts. If you ride in temperatures from below zero to 30 degrees F, Yamaha recommends 5W-30 oil; from 10 degrees F through 100 degrees F, Yamaha recommends 10W-30; from 40 degrees F through 120 degrees F, Yamaha says to use 20W-40 oil.

How do I check the oil level on a Yamaha 600 Grizzly?

Cut the flatbar in two and weld to the pipe. Drill your holes for the lugs and weld a large nut on the end of the pipe. Attach the lug nuts and install the puller bolt. If you do a lot of ATV brakes, the plate type puller will save you time and money.

How do you change oil on a Yamaha Grizzly?

The type of engine oil recommended by Yamaha varies. Park your Grizzly on level ground. Gather the tools needed to change the oil. Remove the three Phillips screws from the left side engine cover. Pull this cover off. Start the engine and let it run for about five minutes (to warm up), then turn it off.

Navigation