Where do the springs go on a carburetor?
The governor primary and secondary springs both clip to the loop in the governor throttle arm linkage. The throttle lever is located on the throttle lever control bracket in front of the carburetor.
How to install a choke control on a carburetor?
Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm). Make sure that the carburetor choke is fully opened before tightening cable clamp. 4.
How do you remove choke cable from car?
Loosen the boot to give you access to the jet. Remove the jet by using your screwdriver to unscrew it. Now you’ll be able to pull the whole assembly, including the boot and the jet, away from the engine. From here you’ll be able to see how the choke cable fits into the carburetor.
Where is the choke and throttle cable located?
Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow.
What should I do before replacing a carburetor and tank?
Install the new carb and tank assembly onto the engine following the opposite order that you removed them. Jack’s Safety Tips: Before servicing or repairing any power equipment, disconnect the spark plug and battery cables.
Insert the cable bowden wire into the choke control (front or reverse pull). Then place choke cable under the cable clamp. 3. Position the choke control so it bottoms, then pull it back approximately 1/16″ (1.5 mm). Make sure that the carburetor choke is fully opened before tightening cable clamp. 4.
Is it easy to replace choke cable on Harley Davidson?
A replacement Harley-Davidson motorcycl choke cable is cheap, and it is pretty easy to replace. While you’re doing the job, it would be a good time to clean your carburetor and install some new gaskets. Loading…
Insert the control cable bowden wire in the proper hole of the engine control lever, which is located on the side of the carburetor air intake elbow.
Where is the air cleaner base on a carburetor?
Disconnect the breather hose from the air cleaner base by pushing downward. Remove the air cleaner base 3/8″ hex. head. retaining screw, air cleaner base, and oval air tube. Leave the air cleaner base gasket on the carburetor air cleaner elbow. 2. Engines with dome style air cleaner start with #3. 3.