Where are the screws for the oil pump?
ELEVATING SCREW GUARD SIGHT GLASS SPINDLE START SPARK GUARD ELEVATING HANDWHEEL SERIAL NUMBER LONGITUDINAL HANDWHEEL PLATEN FRONT VIEW FIGURE 1 CROSS FEEDING LOCKING THUMB SCREW CROSS FEED HANDWHEEL REAR VIEW FIGURE 2 SIDE VIEW FIGURE 3 SPINDLE POWER OIL PUMP COVER OIL CUP DRAIN HOLE LUBE PUMP POWER LINE POWER CROSS FEED LOCKING THUMB SCREW
Can a spindle be turned in both directions?
Spindles can turn in both directions, but blades have a specific direction due to one side having a cutting edge.
Where do you put the oil in the bevel gear?
Before moving the elevating hand wheel to remove the wood brace between the table and spindle housing, remove the plastic temporary dust cover from the top of the column and slowly pour 2 ounces (1/4 cup) of way oil (the gallon container in the “standard accessory box” found on the left rear corner of the machine skid) over the bevel gear.
How do you take a spindle out of a riding mower?
Take out the spindle and separate it from the blade. Typically, there will be 3 bolts securing the spindle to the mower deck. Use the appropriate tool to remove the bolts. Then, slide the spindle out from underneath the mower deck.
Where to install oil pump and distributor spindle?
With a new gasket placed over the drive spindle, install the oil pump and drive spindle assembly so that the projection on the top of the drive spindle is located in the 11:25 o’clock position (between 11 and 12 o’clock). Install the distributor with the metal tip of the rotor pointing toward the No. 1 spark plug tower of the distributor cap.
How to install an oil pump in an engine?
Loosen the mounting bolts and remove the oil pump body with the drive spindle assembly. Before installing the oil pump in the engine, turn the crankshaft so that the No. 1 piston is at TDC of the compression stroke. Fill the pump housing with engine oil, then align the punch mark on the spindle with the hole in the oil pump.
Where is the punch mark on the oil pump?
Fill the pump housing with engine oil, then align the punch mark on the spindle with the hole in the oil pump. With a new gasket placed over the drive spindle, install the oil pump and drive spindle assembly so that the projection on the top of the drive spindle is located in the 11:25 o’clock position (between 11 and 12 o’clock).
Where can I buy an oil pump shaft?
The shafts are made exclusively for us and are available separately by ordering part #6220. The shaft and gear are assembled and pinned here in our shop.