When to cycle the ignition key on a red lightning bolt?
This light informs you of a problem with the Electronic Throttle Control (ETC) system. If a problem is detected while the engine is run- ning, the light will either stay on or flash depending on the nature of the problem. Cycle the ignition key when the vehicle is safely and completely stopped and the shift lever is placed in the PARK position.
What do you do when a lightning bolt comes on your car?
Turn the ignition key to “OFF” position. Start the engine and test the throttle by see if the engine will throttle up. You would need to repeat this procedure any time the battery is disconnected or replaced. If there are any codes in the computer they may relate to the gas pedal position sensor, which could cause the lightning bolt to appear.
What does a red lightning bolt on the dash mean?
The one that looks like a red lightning volt. What does this mean? My car has an automatic transmission. Hi there. The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. Get a code reader and scan the engine for any logged codes.
What does a red warning light on a jeep mean?
Most warning lights are pretty much straight forward but what does the red lightning bolt symbol in a Jeep mean? The red lightning bolt indicates that there is a problem with your Jeep’s Electronic Throttle Control (ETC). This is a system that replaced the mechanical throttle mechanism with a sensor based one.
Why does my Jeep have a red lightning bolt on it?
When the red lightning bolt symbol appears on your Jeep’s dash, it may mean that that the pedal position is not lined up properly causing there to be miscommunication with the sensors that control the motor which opens and closes the throttle.
What to do if you get lightning bolt on your dash?
1. Insert ignition key and turn to “ON” position but do not start the engine 2. Wait for all the warning lights to go out. The check engine light may remain on. 3. Slowly depress the accelerator pedal all the way to the floor. 4. Slowly release the accelerator pedal until it is all the way back up at the rest position.
When did they start putting red lightning bolts on cars?
That’s when the Electronic throttle control was developed. This technology started appearing in cars from around 1990 and is designed to do away with the old mechanism. It is, however, not immune to mechanical faults and the way you know is through the red lightning bolt light on the dash board.
When does the Check Engine light come back on?
The light stayed off for about 10 minutes, but the temperature gauge was floating between bottom and half. Finally it dropped all the way to the bottom. That is when the lightning bolt and check engine light came back on.