What should crankshaft resistance be on Saturn Ion?
Measure the resistance between the crankshaft position sensor’s terminals A and B. (Disengage the DIS module’s five-pin connector first). The resistance should be 700 to 900 ohms. Remove the crankshaft sensor from the engine if the resistance was off.
What to do if your crankshaft sensor is not working?
Issues with the crankshaft sensor can quickly lead to problems that affect the drivability of the vehicle. For this reason, if you suspect your crankshaft position sensor has an issue, have the vehicle inspected by a professional technician right away. They will be able to diagnose your car and replace your crankshaft position sensor if necessary.
How to troubleshoot the ignition system in a Saturn Ion?
It primarily involves checking for sparks on the spark plugs and ignition coils. Remove a park plug wire from the plug and connect it to a spark tester. Ground the tester to the engine, crank the engine and look for a strong spark. Repeat for all the Ion’s wires.
What are the codes for the crankshaft position sensor?
A diagnostic scan tool could show any of the following codes: 1 P0335 Crankshaft Position Sensor A Circuit Malfunction 2 P0336 Crankshaft Position Sensor A Circuit Range/Performance 3 P0337 Crankshaft Position Sensor A Circuit Low Input 4 P0338 Crankshaft Position Sensor A Circuit High Input 5 P0339 Crankshaft Position Sensor A Circuit Intermittent
Measure the resistance between the crankshaft position sensor’s terminals A and B. (Disengage the DIS module’s five-pin connector first). The resistance should be 700 to 900 ohms. Remove the crankshaft sensor from the engine if the resistance was off.
Can a bad crankshaft sensor cause a check engine light?
Another issue of a potential problem with the crankshaft position sensor is an illuminated Check Engine Light. If the computer detects a problem with the crankshaft position sensor’s signal, it will activate the Check Engine Light to alert the driver of the problem. A Check Engine Light can also be set off by a wide variety of other issues.
It primarily involves checking for sparks on the spark plugs and ignition coils. Remove a park plug wire from the plug and connect it to a spark tester. Ground the tester to the engine, crank the engine and look for a strong spark. Repeat for all the Ion’s wires.
What is the code for a bad crankshaft position sensor?
A diagnostic scan tool will show a code between P0335 and P0338. The check engine light doesn’t always come on, though, so you could be experiencing any of the above symptoms for some time before you see the warning light. There are a number of different problems that can cause similar symptoms to a crankshaft position sensor problem.