What kind of condition does a Jeep Wrangler TJ have?
33 An open or shorted condition detected in the duty cycle purge solenoid circuit. 34 An open or shorted condition detected in the Speed Control vacuum or vent solenoid circuits. Speed control switch input below the minimum acceptable voltage.
What is the trouble code on a Jeep Wrangler?
Count the number of times the check engine lamp on the dash flashes. The number of flashes represents the error code. There will be a short pause between the flashes representing the different digits of the code. Longer pauses separate individual trouble codes. Code 55 will be the last code to be displayed.
What causes a Jeep Wrangler to stop running?
The crankshaft and camshaft sensors are responsible for telling the engine where the crank and cam are located in their 360° revolutions. If they stop reporting this data, even momentarily, the vehicle will not know when to fire the spark plugs and it’ll stop running.
What is the knock sensor on a Jeep Wrangler TJ?
320 Crankshaft position sensor reference signal cannot be found while the engine is cranking. 325 Knock sensor (#1) signal is wrong. 330 Knock sensor (#2) signal is wrong. 350 A coil is drawing too much current. 401 A required change in air/fuel mixture was not detected during diagnostic test.
Is the TJ 4 cylinder too much power?
If the 4 cylinder is able to carry the vehicle without it being a strain, I may have to rethink the 6 vs the 4. Click to expand… Stick with the 6. Don’t think I’ve ever heard someone say they have too much power, but some in this thread have said their 4 doesn’t have enough.
What are the reviews of the 2004 Jeep Wrangler?
CARFAX used car owners give the 2004 Jeep Wrangler 4.2 stars out of 5, with a total of 15 reviews. Reviewers especially like the 2004 Wrangler for its interior and performance. What is the MPG of the 2004 Jeep Wrangler?
Are there 4 cylinders in a Jeep Wrangler?
Are TJ 4 Cylinders Enough Hey everyone! Enter your ride HERE to be a part of MAY’s Ride of the Month Challenge! To get the job done? Since the TJ chassis weighs the same, whether it’s carrying the 4 cylinder or the 6 cylinder, I was just wondering if the 4 cylinder engine has to struggle to power the vehicle.
Why does my Jeep Wrangler have hard start condition?
I did have an issue once before where I changed the fuel pump assembly and the new gasket that came with it was faulty. However, since then, another new pump and gasket have been in the jeep for 3 months and the hard start condition just appeared. I do not have a CEL on.