What kind of bike is a 1986 Yamaha Virago?
Four months ago I gave up the passenger seat on Per’s Road King, and I climbed atop a 1986 Yamaha Virago 700cc. There are reviews and tests of new motorcycles. Potential buyers can find the results in numerous publications, but it is much more difficult to find the same kind of information about used bikes.
When did the Yamaha Virago 700 come out?
Yamaha continued to produce the Virago with only slight changes each year until 1984. That year, the United States levied new tariff regulations against imported motorcycles over 700cc, so the Yamaha Virago 700 was born. It still had all the appeal and performance of earlier models except for a slightly reduced displacement.
What are the symptoms of a faulty Yamaha Virago starter?
Symptoms of a faulty electrical starter on the Yamaha Virago motorcycle include: Typically, the engine should come to life immediately on pressing the starter. However, if the starter turns slowly and the bike cannot start promptly, something is wrong with the starter. II. Starter Makes a Clicking Noise:
What kind of oil does a Yamaha Virago use?
Virago Specifications Engine oil XV-920 (1981-1982 CHAIN DRIVE) 8.9 oz (264 cc) XV-920 (1981-1982 SHAFTDRIVE) 10.2 oz (303 cc) XV-1000, XV-1100 12.6 oz (372 cc) Final Gear Oil (SHAFT DRIVE) .21 qts (200 cc)
What should I do about my Yamaha Virago 750?
The XV-700’s and 750’s require a different repair because they do not have the starter clutch. Yamaha suggests changing the large tension clip, P/N 904-68291-06-00, on the idler gear. Look for wear in the clip groove. Hand grind smooth. Replace the idler gear also. A dealer would use a spring gauge to check the tension of the spring clip.
Is the starter on a Yamaha Virago defective?
The Virago is no different than any other motorcycle manufacturer when it comes to having defects in design or manufacturing. In Yamaha’s case, it is the starter employed by the Virago that has become the primary complaint.
Where is the compression spring on a Yamaha Virago?
Replace the idler gear compression spring, P/N 905-01156-36-00, and starter gear tension clip, P/N 904-68291-14-00. These parts are located inside the left side cover. Yamaha does not recommend welding the starter ring gear because if the engine should backfire you could do serious damage to the case.
Can You welding the starter on a virago?
Yamaha does not recommend welding the starter ring gear because if the engine should backfire you could do serious damage to the case. I know that this method of repair worked for many club members, but if locking-in the ring gear was a design requirement, I’m sure that Yamaha would have avoided this flaw.