What is the purpose of a ball joint press?
A ball joint press is used to remove the ball joints from a control arm that was pressed in from the manufacturer. Most aftermarket ball joints are bolt-on designs that replace the pressed-in ball joint.
Can you ride with bad ball joints?
Can I Drive With a Bad Ball Joint? No. You should not drive with a bad ball joint. Continuing to drive can cause damage to other vehicle components and if the joint fails completely you could lose control of the vehicle, leading to a crash and injuries.
How do you remove a ball joint from a Marquis?
Remove the wheel hub and the brake components to access the control arm and ball joints. Use the ball joint press to remove the ball joint from the Marquis. The ball joint cannot be removed without a ball joint press. Install the new ball joint using the ball joint press; do not remove the protective cover while installing it.
How do you remove a wheel from a Marquis?
Use the side mounts to support the vehicle with the jack stands. Use the four-way lug wrench to remove the wheel (s). Remove the wheel hub and the brake components to access the control arm and ball joints. Use the ball joint press to remove the ball joint from the Marquis. The ball joint cannot be removed without a ball joint press.
Is the Mercury Grand Marquis rear wheel drive?
The Mercury Grand Marquis is one of the last full-size, rear-wheel drive cars on the market. The Grand Marquis shares chassis components with its cousin, the Ford Crown Victoria. Both vehicles are built on the Ford Panther platform that has changed little since its introduction in 1979.
What do I need to replace a worn out ball joint?
If your vehicle has a strut-type suspension, or any other type of suspension system that doesn’t involve the need to compress the springs and unload the control arms, you can easily replace the worn-out part using simple hand tools. If your vehicle uses upper and lower control arms, you’ll need a spring compressor.
How much does ball joint replacement cost on Mercury Grand Marquis?
Mercury Grand Marquis Ball Joint Replacement (Front) costs $243 on average. What is the Ball Joint Front all about? Ball joints are a part of your vehicle’s suspension system that connect the steering knuckles to the control arms.
Use the side mounts to support the vehicle with the jack stands. Use the four-way lug wrench to remove the wheel (s). Remove the wheel hub and the brake components to access the control arm and ball joints. Use the ball joint press to remove the ball joint from the Marquis. The ball joint cannot be removed without a ball joint press.
The Mercury Grand Marquis is one of the last full-size, rear-wheel drive cars on the market. The Grand Marquis shares chassis components with its cousin, the Ford Crown Victoria. Both vehicles are built on the Ford Panther platform that has changed little since its introduction in 1979.
Can a ball joint be installed without a press?
The ball joint cannot be removed without a ball joint press. Install the new ball joint using the ball joint press; do not remove the protective cover while installing it. Once the ball joint is fully tightened, remove the cover from the joint. You may have to trim the protective cover to remove it.