What is the code for an 08 International DT466?
Working on a 08 international 4300 dt466, many codes, only 2 are active, 221-4 and 254-6, the 221 code is listed twice. Also the vin and registration … read more I have a 2005 4300 DT466 running rough, black smoke, no power & hardly accelerates sputters & dies out.
What are the trouble codes for International trucks?
International Trucks Diagnostics Trouble Codes (DTCs) for Model: 3200, 4100, 4300, 4400, 7300, 7400, 7500, 7600, 7700, 8500, 8600, BE 200, CE Bus, CXT, DuraStar, LoneStar, MXT, ProStar, RXT, TranStar, WorkStar
Where to find DT 466E trouble code list?
You can go to this site: https://evalue.internationaldelivers.com/service/bodybuilder/general/engine/eges270_FC.xml and click on the actual code (DTC) to access some decent diagnosis pages! Or scroll down for a quick reference. One word of *CAUTION*
What is the code for no IDM injector?
Working on a 2005 international with a dt466 had a code for… working on a 2005 international… working on a 2005 international with a dt466 had a code for #1 and#5 injector replaced them both now I have a code for no idm and ecm commiunication position signals. The CKPO and CMPO channels are in phase with the CKP and CMP
What’s the trouble code for a 1995 dt466e?
That is good for 1995-1999 DT466E engines. Good Day! I’ll sticky this for you guys…. I can also post the newer engine DTC lists if you would like. If you could post the trouble codes for the later DT466E i would appreciate it. I have ordered the Intl. CD Manual but would like to start on the codes in my 2002 truck.
What’s the code for a DT 466E diesel truck?
We got couple of 05 International truck that has VGT problem. Code 152 (BAP signal out of range low). 354 (VGT control under duty cycle) and Body Controller – Remote Engine Speed Control #1 – Analog input #2 shorted to ground. Already replace BAP sensor, MAP sensor and VGT turbo.
What does DTC 543 do on a DT466?
There is no relation a vehicle.Fault Detection / ManagementThe ECM continuously monitors the IDM. When the ECM fails to receive required communicating with the IDM. circuit is open. If IDM power is low, DTC 543 can be set. ECM). See “EGR Actuator” in this section. One of
Can a 2005 International shut off while driving?
I have a 2005 International with a DT466. The issue I’m having is without warning, while driving down the road the truck will lose power and then shut off. No engine light comes on, no codes in the Dash changed the fuel filter checked the fuses in the battery box, Checked the relays underneath the hood and replaced the camshaft sensor.
What should fuel pressure be in 2005 DT466?
You will see the pressure relief ball. It may be partially unseated by debris causing a drop in fuel pressure. Anyway, you will notice a compuchek fitting on the top of the filter housing cap. You plug in a fuel pressure gauge here to test your fuel pressure. Need 20 psi to start, 65 psi is normal running pressure.