What is code 0306 on Jeep Liberty?
0306 code constantly no matter what you do. Always triggered while idling. Compression test good, leak down test good, new plugs, coils, injectors, cleaned throttle, O2 sensors all four, check valves no vacuum leaks. Cur runs normally but nothing fixes codes.
What is the code on my Jeep Liberty?
Code indicated a misfire in the #2 cylinder. Am taking it to a mechanic today to have it checked. When engine is first turned on sounds fantastic.
How much does it cost to repair a Jeep Liberty?
The average cost for a Jeep Liberty General Diagnosis is between $88 -$111. Learn More After flushing the radiator, my 2002 jeep liberty engine light came on. misfire. cyl 2,3 and 6. my o2 sensor is bad too. i change all spark plugs and ignition coil for cyl 6. nothing seems to work.
Why does my Jeep Liberty light come on again?
Light came on again (misfire on cylinder 4) – switched coil from 4 to 2. Light came on again (misfire on cylinder 4) – found out today that every valve on the right side of the engine is burnt. The story from the mechanic it is that due to some carbon build up and it has caused the valve guides to go bad.
How do you change the spark plug on a Jeep Liberty?
Tighten the spark plug into the cylinder head with the spark plug socket by 1/4 of a turn. Take care not to over tighten the plug, which may cause the it to break.
Are there any problems with the Jeep Liberty 3.7 engine?
According to one leading engine builder, Chrysler’s 3.7-liter engine has some fatal flaws. The engine builder also adds that if not attended to, there could be some serious as well as catastrophic vehicle failures just after the warranty expires.
Where is the draincock on a Jeep Liberty?
SERIOUS BURNS FROM COOLANT CAN OCCUR. (1) DO NOT remove radiator cap first. With engine cold, raise vehicle on a hoist and locate radiator draincock. NOTE: Radiator draincock is located on the left/lower side of radiator facing to rear of vehicle. (2) Attach one end of a hose to the draincock.
How do you change coolant in a Jeep Liberty?
Install the thermostat and housing with a replacement gasket (Refer to 7 COOLING/ENGINE/ENGINE COOLANT THERMOSTAT – INSTALLATION). Connect the radiator hoses. Refill the cooling system with the correct antifreeze/water mixture (Refer to 7 – COOLING – STANDARD PROCEDURE).