What does p1298 mean on Honda Charger?
If your Honda vehicle has stored a code P1298, it means that the powertrain control module (PCM) has detected a problem with part of the charging system known as the electronic load detector (ELD) or ELD circuit. This code specifically pertains to a condition in which a voltage signal that is higher than anticipated has been perceived.
How much does it cost to fix a p1298 Honda?
What does this mean? The cost of diagnosing the P1298 HONDA code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.
What does error code p1298 mean on Eld?
Error Code P1298 is defined as Electric Load Detector Circuit High Voltage. This means the ELD (Electric Load Detector) is getting high input voltage. This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present.
How to reset the p1298 load detector code?
Connect the scanner to the vehicle diagnostic connector and retrieve stored codes and freeze frame data. Write it down as it will almost always come in handy if the diagnosis drags on due to an intermittent condition. Clear the codes and operate the vehicle under various electrical load conditions to see if the code P1298 is reset.
When did Honda p1298 Eld circuit voltage high trouble code?
On May 6, 2005 Honda issued a service bulletin #05-006 to address the issue a P1298 ELD circuit voltage high trouble code. The service bulletin advises that Honda has discovered a faulty solder joint on the ELD and recommends replacement with an updated part #38255-S5A-003, H/C 7987571.
Why does my car have an error code p1298?
Usually, there are no other noticeable symptoms. In some cases, however, the engine may suffer rough idle, especially when the vehicle settles down or transitions from high throttle to rest, or the engine feels like it’s misfiring. There are multiple reasons for this code to appear, some of the most common causes include:
What to do when your load detector says p1298?
If the code comes back, turn the off both the headlights and the ignition. Disconnect the ELD 3P connector, which is located behind or underneath the under hood fuse box.
What is the error code for Honda Civic?
This error code is a manufacturer-specific trouble code, meaning it does not appear to all vehicle makes and models with OBD-II system or vehicles made since 1996 up to present. Rather, it applies to select vehicle manufacturers, most commonly among Honda vehicles like Honda Accord, Honda Civic, and Honda CR-V.